HP 5000C/CT manual Icon Assembly

Page 30

Figure 5 - Icon Assembly

Lift the display straight up about 1 inch. The Icon Assembly will lift up with the display. Move the Icon assembly out of the way. The cable from the Icon Assembly to the PC board does not need to be removed if only the display is being removed. Otherwise, slide the connector sleeve up to remove the Icon Assembly cable.

If only the Icon assembly is to be removed, the display may be lowered back into position.

To remove the Display Assembly, remove the two cables attaching the display module to the PC board. Lastly, remove the two screws attaching the grounding straps to the PC board. The display can now be removed the rest of the way.

30

Image 30

Contents HP OmniBook 5000C/CT Familiarization GuidePage Table of Contents Disk Configuration Table of Figures Memory Door and SlotOmniBook Product Comparisons HP OmniBook Power Removable ModulesMass Storage HP OmniBook Audio PortsPre-installed Software HP OmniBook ExpandabilitySecurity OmniBook 5000 Series Product Features ModelsProduct Description Part Number Product Description Part Number Product Description Part Number Accessories Description Part Number OmniBook 5000 enhancements over the OmniBookBox SlotsPossible Memory Memory Slot Total RAM Configurations Hard Drive 540MB 810 MB 215MB HDD IBMFlexible disk drive Built-in I/OResolution Maximum colors Display/VideoUser interface Management standard Approx 16MB, VGA, DstnCharger Environment TestingOperating Storage environmentPassword Decode Supported OperatingSystems Password Decode Policy Installing memory Field Replaceable AssembliesBattery Module and Floppy Disk Drive Module Hard Disk Drive Small parts Icon Assembly and Display Module HP Authorized Service Providers OnlyIcon Assembly Display Removal Palm Rest Assembly and Track Ball Assembly To replace, reverse the above procedure Keyboard Assembly and Power Board PCB Assy DC Power PI-DC Keyboard and Power BoardUpper Cover Assembly and Icon Board PCB Assy PI-ICON Components to remove prior to Upper CoverHeat Pipe Replacement Procedure CPU Module and Heat Sink HP Authorized Support Providers OnlyCPU Module and Heat Sink System Board PCB Assy PI-586 Standoff 11.75 mm Configuration and Setup Main Configuration ScreenPower Screen Power Control ScreenPower Configuration Setting Parameters Default CommentsSystem Configuration Input/Output Configuration COM1,COM4 IRQInput/Output Screen Disk Configuration Troubleshooting and Repair OmniBook Self-TestFirst Post Beep Codes Beep Code Description System halt Last Post Display CodesPhoenixBIOS Post Messages Power On Self Test Message Possible CausePOST. Pressing the Fl key allows the system to Appendix a Part Numbers Description HP Part Number Exchange PartSUB Battery SET