ACCESSORIES
Refer to Price Manual for specific model numbers.
Start Assist Kit (2SA067*)
Blower Time Delay - Available to increase efficiency when installed. Installs on indoor section and maintains blower for approximately one minute after cooling thermostat has been satisfied.
Hard Start Kits - Provides required starting torque for use with Thermal Expansion Valve Kit.
Low Temperature Cutout (2LT06700224) - Prevents heat pump operation below
Compressor Blanket - Designed to further reduce the nor- mal operating sound.
Thermal Expansion Valve Kit - 1TVM Series TXV kit used to improve system performance.
Outdoor Thermostat (2TD06700124) - Provides additional staging of supplemental electric heat.
TYPICAL INSTALLATION
2H/1C, manual changeover electronic
3H/2C,
3H/2C, auto/manual changeover, electronic programmable,
*For the most current accessory information, refer to the price book or consult factory.
SOUND POWER RATINGS
UNIT MODEL |
| (dBA)* | |
|
|
| |
| Cooling |
| Heating |
018 | TBD |
| TBD |
024 | TBD |
| TBD |
030 | TBD |
| TBD |
036 | TBD |
| TBD |
042 | TBD |
| TBD |
048 | TBD |
| TBD |
060 | TBD |
| TBD |
* Rated in accordance with ARI
60” OVERHEAD CLEARANCE
6” CLEARANCE AROUND PERIMETER
NOTE:
ALL OUTDOOR WIRING
MUST BE WEATHERPROOF.
MINIMUM 18” SERVICE
ACCESS CLEARANCETHERMOSTAT
ON ONE SIDE
WEATHERPROOF
DISCONNECT
SWITCH
NEC CLASS 1 WIRING
TO FURNACE OR
AIR HANDLER
TERMINAL BLOCK
NEC CLASS 2 WIRING
TO INDOOR COIL
CONTROL |
|
ACCESS | SEAL OPENING(S) WITH |
PANEL | PERMAGUM OR EQUIVALENT |
TYPICAL FIELD WIRING
ALL FIELD WIRING TO BE IN ACCORDANCE WITH ELECTRIC CODE (NEC) AND/OR LOCAL CODES
POWER WIRING
(NEC CLASS 2)
POWER WIRING CONTROL WIRING FACTORY WIRING
CONTACTOR
TERMINALS
GND.
LUGCOIL
CONDENSING UNIT
FURNACE OR AIR HANDLER TERMINAL BLOCK
C Y R G W
* TERMINAL W IS ONLY REQUIRED ON SYSTEMS WITH HEAT.
*
Y R G W
ROOM THERMOSTAT
ALL OUTDOOR WIRING MUST BE WEATHERPROOF. USE COPPER CONDUCTORS ONLY.
Johnson Controls Unitary Products | 15 |