Wiring Connections

Physical Installation

1.On the rear of the SA8220, connect the provided AC power cable.

2.Refer to this diagram for all wiring connections on the front panel of the SA8220.

Network Server Power

Status

Console	Act 1

Failover

Act 2

NOTE: For more information about serial cable failover, see Chapter 2 in the User Guide.

Front Panel Ports and LEDs

3.For Single NIC (Network Interface Card) configurations: Connect the Network port to your network using the provided RJ- 45 network cable.

For Dual NIC configurations: Connect the Network port to your outside network, and the Server port to your server side network, using the provided RJ-45 network cable and a network cable you provide, respectively.

4.Use the provided serial cable to connect the Console serial port to the serial port of any terminal or workstation capable of running a terminal emulator program.

5.If you use cable-based failover to manage a backup SA8220, connect the second SA8220 in the manner described above and connect the Failover ports of the two units using the serial cable provided with the backup SA8220.

6.If the power is not already on, turn on the SA8220 using the Reset switch on the rear panel.