HP d3000 manual Appendix, Troubleshooting, Specifications, About Folder and File Names

Appendix

About Folder and File Names

Your camera automatically creates specific directory of folder in the internal memory cards to organize captured images, videos and audio files.

File Naming

File names begin with "DSCI" and followed by a 4-digit number that increases in sequence. File numbering starts from 0001 when a new folder is created.

If the highest folder number is 999 and the highest file number exceeds 9999, the camera will display the warning message "Folder cannot be created". When this happens, try one of the following ways:

•Reset the file number. See "Setting File Numbering" on page 56.

Do not change the folder and file names in the memory card using your PC. It may be unable to playback the data using the camera.

Troubleshooting

Problem	Cause and/or Action
Camera does not turn on.	The batteries may be exhausted. Replace the batteries.
Camera turns off	Press Power button to turn on the camera.
automatically.
LCD turns dark.	Press any button except the Power button to turn on the LCD.
Empty battery icon is
displayed on the LCD,	Batteries are exhausted, please replace the batteries.
then the camera turns off.
LCD monitor displays	There is no image file in the memory card. Image file format may not
"No image".	be supported.
LCD monitor displays	Function is only available for specific file types. File format is not
"Not available for this
	supported.
file".
LCD monitor displays	Memory card is full. Replace the memory card with a new one or delete
"Memory full".	unnecessary images.
LCD monitor displays	This file is locked. Unlock the file. See "Protect" on page 49.
"File locked".
LCD monitor displays	The memory card is protected. Remove the card and slide the
"Card locked".	write-protect switch to its unlock position.
LCD monitor displays	The card may be damaged. You can either change the card or wipe to
"Format error".	clean the connected points.
LCD monitor displays	The memory card is protected. Remove the card and slide the
	write-protect switch to its unlock position.
"Copy error".
	The memory card is full. Replace card or delete unnecessary files.
No image displays on the	Incorrect TV-out type was selected. Set the correct TV-out type to
TV screen.	match your TV system.
The lens got stuck up.	Do not force the lens to go back.
	The type of the battery used may be incorrect or the battery power
	level is too low. Change the battery before using the camera.

Specifications

Sensor

Sony 16M CCD

63