To install a new optical drive:
NOTE: Make sure the jumper on the new drive is in the CS (Cable Select) position.
1Slide the new optical drive through the front of the computer. Don’t slide the drive in all the way — you need room to attach the cables.
2Connect the cables to the back of the drive(s).
3Push the drive(s) all the way in, align the screw holes and insert the screws as follows:
•Upper drive bay,
•Lower drive bay,
•Lower drive bay,
NOTE: The
To reassemble the computer:
1Replace the fan duct and side panel (see “closing the computer“ on page 140).
2Skip this step if you are installing a
H
Chassis I and Chassis II only
NOTE: This step applies only to Chassis I and II, and is not available for Chassis III.