HP FX75 manual Unpacking the Display, Positioning the Display, Installation

Page 9

Follow the instructions in this chapter to install your HP Pavilion FX75 Flat Panel Display.

Note: Before connecting your display, first read through the instructions in this chapter and the safety precautions in the previous chapter.

Unpacking the Display

When you unpack the display, make sure that you have the following items:

NThe display

NA/C power adapter with attached power cable

NA power cord

NAnalog video signal cable

NAudio cable

NDriver diskette

Positioning the Display

Place the display on a flat, sturdy surface. Choose an area free from excessive heat, moisture, and sunlight. Avoid possible sources of electromagnetic interference, such as transformers, motors, and fluorescent lighting.

Installation 5

Filename: fx75UGrw.doc	Title: Book Title
Template: HP-Print.dot	Author: WASSER, Inc. Last Saved By: WASSER, Inc.

Revision #: 30 Page: 5 of 43 Printed: 10/16/00 03:31 PM

Image 9

Contents HP Pavilion FX75 Flat Panel Display User’s Guide Revision # 30 Page 2 of 43 Printed 10/16/00 0331 PM Contents Iv HP Pavilion FX75 Flat Panel Display User’s Guide Introduction Introduction For Your Safety Do not cover the air vents HP Pavilion FX75 Flat Panel Display User’s Guide Display has been dropped or the cabinet has been damaged Installation Installation Unpacking the DisplayPositioning the Display Connecting the Power and Video Cables Plug the two-prong power cord into a power Connecting Stereo Speaker System Display. The jack is colored blue to match On the audio cable. This connector is labeled subwooferCable plug Is locatedUsing the Display Turning the Display On and Off Power buttonTilting the Display Using Screen SaversSince the inherent format of the FX75 display is Setting the Video ModeSetting the Refresh Rate Minimizing Energy Use Caring For Cleaning the DisplayCleaning the Screen Changing Display Settings Changing Display SettingsDisplaying the OSD Window Using the Control ButtonsOption Description New modeSelecting Options OSD Window Press the Select button to execute your selection Using Auto SetupPress the Select button again to choose Auto Setup Adjusting the ImageTable below briefly describes each of these functions Positioning the ImageScaling options are Selecting a Scaling ModeAdjusting the Sharpness Level Adjusting Gamma Correction Adjusting Color SettingsSee Saving and Restoring Color Settings on Adjusting Color TemperatureTo adjust color temperature Adjusting RGB or Black Level Saving and Restoring Color Settings Adjusting the Phase and Clock Adjusting Advanced SettingsTo select the video interface Selecting the Video InterfaceMessage Check Cable appears on my display TroubleshootingTroubleshooting Message Unknown Mode Detected appears on my displayFX75 Display Information Technical InformationUnknown Video Modes FX75 Video ModesDeclaration of Conformity Regulatory InformationRegulatory Information FCC StatementGeneral Notice Revision # 30 Page 39 of 43 Printed 10/16/00 0331 PM