HP FX75 manual Contents

Page 3

Contents
Introduction	1
For Your Safety	2
Installation	4
Unpacking the Display	5
Positioning the Display	5
Connecting the Power and Video Cables	6
Connecting the Stereo Speaker System	8
Using the Display	10
Turning the Display On and Off	11
Tilting the Display	12
Setting the Video Mode	13
Setting the Refresh Rate	14
Minimizing Energy Use	15
Caring For and Cleaning the Display	15

Changing Display Settings	17
Using the Control Buttons	18
Displaying the OSD Window	18
Selecting Options in the OSD Window	20
Using Auto Setup	21
Adjusting the Image	22
Troubleshooting	32
Technical Information	34
FX75 Display Information	34
FX75 Video Modes	35
Unknown Video Modes	35
Regulatory Information	36
Declaration of Conformity	36
FCC Statement	37
General Notice	38
Contents	iii

Filename: fx75UGrw.doc	Title: Book Title
Template: HP-Print.dot	Author: WASSER, Inc. Last Saved By: WASSER, Inc.

Revision #: 30 Page: 3 of 43 Printed: 10/16/00 03:31 PM

Image 3

Contents HP Pavilion FX75 Flat Panel Display User’s Guide Revision # 30 Page 2 of 43 Printed 10/16/00 0331 PM Contents Iv HP Pavilion FX75 Flat Panel Display User’s Guide Introduction IntroductionFor Your Safety Do not cover the air ventsHP Pavilion FX75 Flat Panel Display User’s Guide Display has been dropped or the cabinet has been damaged Installation Installation Unpacking the DisplayPositioning the Display Connecting the Power and Video Cables Plug the two-prong power cord into a power Connecting Stereo Speaker System Is located On the audio cable. This connector is labeled subwooferDisplay. The jack is colored blue to match Cable plugUsing the Display Turning the Display On and Off Power buttonTilting the Display Using Screen SaversSince the inherent format of the FX75 display is Setting the Video ModeSetting the Refresh Rate Minimizing Energy Use Caring For Cleaning the DisplayCleaning the Screen Changing Display Settings Changing Display SettingsDisplaying the OSD Window Using the Control ButtonsOption Description New modeSelecting Options OSD Window Press the Select button to execute your selection Using Auto SetupPress the Select button again to choose Auto Setup Adjusting the ImageTable below briefly describes each of these functions Positioning the ImageScaling options are Selecting a Scaling ModeAdjusting the Sharpness Level Adjusting Gamma Correction Adjusting Color SettingsSee Saving and Restoring Color Settings on Adjusting Color TemperatureTo adjust color temperature Adjusting RGB or Black Level Saving and Restoring Color Settings Adjusting the Phase and Clock Adjusting Advanced SettingsTo select the video interface Selecting the Video InterfaceMessage Check Cable appears on my display TroubleshootingTroubleshooting Message Unknown Mode Detected appears on my displayFX75 Display Information Technical InformationUnknown Video Modes FX75 Video ModesDeclaration of Conformity Regulatory InformationRegulatory Information FCC StatementGeneral Notice Revision # 30 Page 39 of 43 Printed 10/16/00 0331 PM