HP L1510 15” LCD Monitor
Using Your Monitor
To access the Recall function, first select Information, then select Recall from the
Recall: If you press 
, factory preset settings will be recalled. The settings that are affected by the Recall function are
RECALL EXIT
•Screen Geometry
•Horizontal Frequency
•Vertical Frequency
•Brightness / Contrast
WARNING By pressing the 
button all previous adjustments are lost (refer to “Adjusting Your Monitor” on page 10 to adjust the monitor again).
NOTE
Setting the Amount of Displayed Information
To set the amount of displayed information, change the screen resolution of your computer. The higher the screen resolution, the more information you can see on the screen. It is recommended that you use a resolution of 1024 x 768. It is recommended that you use a refresh rate of 60 Hz. The image refresh rate is the number of times per second that the image is redrawn.
LCD technology does not cause any flicker at low refresh rates.
Minimizing Energy Consumption
If your computer supports VESA monitor power management (available on many HP computers), you can minimize the power consumed by the monitor. There are two power saving modes:
•Suspend mode (uses less than 5W)
•Sleep mode (uses less than 5W)
When the monitor enters power saving mode, the message No Signal is displayed for a few seconds before the screen blanks. In power saving mode the front panel indicator light is amber.
To set these power saving modes, refer to the manual that came with your computer.
English 21