HP LE1902X, LE2002XM manual Removing the Monitor Pedestal Base, Mounting the Monitor

Page 15

Removing the Monitor Pedestal Base

You can remove the monitor panel from the pedestal base to install the panel on a wall, a swing arm, or other mounting fixture.

CAUTION: Before beginning to disassemble the monitor, be sure the monitor is turned off and the power and signal cables are both disconnected.

1.Disconnect and remove the signal and power cables from the monitor.

2.Lay the monitor face down on a flat surface covered by a clean, dry cloth.

3.Remove the four pedestal neck screws (1) and lift the pedestal neck (2) off of the monitor panel. Figure 2-8Removing the Pedestal Neck Screws

Mounting the Monitor

The monitor panel can be attached to a wall, swing arm, or other mounting fixture.

NOTE: This apparatus is intended to be supported by UL or CSA Listed wall mount bracket.

1.Remove the monitor panel from the pedestal base. Refer to Removing the Monitor Pedestal Base on page 9.

CAUTION: This monitor supports the VESA industry standard 100 mm mounting holes. To attach a third-party mounting solution to the monitor, four 4 mm, 0.7 pitch, and 10 mm long screws are required. Longer screws must not be used because they may damage the monitor. It is important to verify that the manufacturer’s mounting solution is compliant with the VESA standard and is rated to support the weight of the monitor display panel. For best performance, it is important to use the power and video cables provided with the monitor.

ENWW

Removing the Monitor Pedestal Base 9

Page 14 Page 16
Image 15
Page 14 Page 16
Contents User Guide Second Edition December Document Part Number About This Guide Iv About This Guide Table of contents Enww HP LCD Monitors Product FeaturesEnww Attaching the Monitor Base Setting Up the MonitorComponent Function Rear ComponentsConnecting the Cables 5Installing the Cable Management Clip Setting Up the Monitor 1Monitor Front Panel Controls Front Panel ControlsTurning on the Monitor Adjusting the MonitorMounting the Monitor Removing the Monitor Pedestal BaseInstalling a Cable Lock Finding More Information LE1902x Model Technical Specifications1LE1902x Specifications 2LE2002x and LE2002xm SpecificationsLE2002x and LE2002xm Models Recognizing Preset Display ResolutionsLE2202x Model LE1902x ModelLE2202x Model Energy Saver Feature6Factory Preset Modes Entering User ModesEnergy Saver Feature
Top Page Image Contents