Analog Analysis
Installation Quick Reference
Since the PCI Scope Preprocessor interface contains only passive matching terminators it introduces negligible skew to the PCI Local Bus signals.
The following procedure describes the major steps required to perform analog analysis measurements with the PCI Scope Preprocessor module.
1.Install the PCI Scope Preprocessor module into a slot in the target PCI Local bus.
2.Load the PCI MultiProbe configuration file
PCI_MUL.DUT from the MULTIPRB directory on the hard disk. See page 9 for details on how to load this file.
Once the file is loaded the POD that is connected to the PCI Scope Preprocessor will be assigned the name PCI LogicScope as shown below
11