HP 110 manual Make copies, Increase copy speed or quality

Cam.book Page 14 Friday, February 25, 2000 11:32 AM

HP Color Copier

Make copies

All copy settings selected on the front panel are reset two minutes after the unit completes the copy job unless you save the settings as the default settings.

1Load the input tray with the appropriate paper.

For more information, see “Load paper or transparency film, or load originals.”

2If you are using anything other than plain paper, press Paper Type, press until the appropriate type appears, and then press ENTER to select it.

For more information, see “Recommended paper-type settings for copying.”

3Load your original.

For more information, see “Load originals on the glass” or “Load originals in the automatic document feeder (ADF).”

4If you want to make more than one copy (the default), press Number of Copies, and then use the keypad to enter the number of copies.

For more information, see “Set the number of copies.”

5Change any other applicable settings, such as reduction, enlargement, or special features.

6Press Start Copy, Black or Color.

Increase copy speed or quality

Your unit provides three options that affect copy speed and quality.

•Best produces the highest quality for all paper and eliminates the banding (striping) effect that sometimes occurs in solid areas. Best copies more slowly than the other quality settings.

•Normal delivers high-quality output and is the recommended setting for most of your copying. Normal is the recommended setting for all paper types and is faster than Best.

•Fast copies faster than the Normal setting. The text is of comparable quality to the Normal setting, but the graphics may be of lower quality. Using Fast also cuts down on the frequency of replacing your print cartridges because it uses less ink.

To change the setting

`Press Quality until the light next to the setting you want to use is lit.

14 Chapter 4—Use the copy features