HP 2995 manual Choose a Suitable Location, Mount Control

Page 7

Step 2. Choose a Suitable Location

The installation site directly impacts the functionality and lifespan of the control.

Avoid areas where surrounding air temperature exceeds 40OC (direct sunlight or near heating equipment or inside a panel without a cooling fan. Avoid locations where the front panel dial and switch may be bumped and accidentally turned on/off or damaged.

Avoid environments with corrosive gas.

Avoid locations near radioactive matter or flammable material.

Avoid locations near equipment that generate electromagnetic interference (soldering or power machinery).

Avoid mounting the control to a surface that vibrates.

Step 3 – Mount the

Control

Prepare the mounting surface by drilling four holes with their centers located as shown in Figure 3. If #10 screws are to be used for mounting, then use a #6 (.204) clearance drill. If #10-32 machine screws are to be used for mounting, then use a #20

(.161) tap drill. After the mounting surface has been prepared, mount the control with screws through the four mounting brackets (already attached to back of control enclosure).

Figure 3 - Mounting

Dimensions

7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Phase AC Motor Speed Control Quick Reference Table of Contents Electrical Ratings Product SpecificationsImportant Safety Precautions Examine before installation InstallationMount Control Choose a Suitable LocationConnection Preliminary SetupPage Electrical connections for Model Connect the MotorConnect AC Line Cord Connect to AC PowerClose and Seal the Enclosure Check System Before Starting OperationOperate the Inverter Adjust Trim Pots OptionalMIN Minimum Speed DEC/B Deceleration with 60 Hz or 120 Hz configuration CL Current Limit with I2t Shutdown Abnormality Check Point Countermeasure TroubleshootingOperating LED LED Flash Corrective Type HPP-5337E4 AC Motor Speed Control, Model number Declaration of ConformityBodine Limited Warranty
Top Page Image Contents