HP 2995 manual Connect AC Line Cord, Close and Seal the Enclosure, Connect to AC Power

Figure 8 - Connection diagram for Bodine 230V inverter-duty motors.

Figure 9 - Connection diagram for Bodine 230/460V inverter-duty motors wired for 230V operation.

Table 3 - Direction of Bodine motor driveshaft rotation, viewing end of driveshaft, when connected per the diagrams at the left and with control set for “forward” direction

Bodine Motor Type	Direction
30R2BEPP	CCW
30R4BEPP	CCW
30R2BEPP-D3	CW
30R4BEPP-D3	CW
30R2BEPP-D4	CCW
30R4BEPP-3N	CCW
34R6BEPP-Z2	CCW
34R6BEPP-Z3	CCW
34R6BEPP-Z4	CW
34R4BFPP-E1	CCW
34R4BFPP-E2	CW
34R4BFPP-E3	CCW
34R4BFPP-E4	CW
34R6BFPP	CW
34R6BFYP	CW
42R6BFPP	CCW
42R6BFPP-GB	CW
42R6BFPP-F1	CW
42R6BFPP-F2	CCW
42R6BFPP-F3	CW
42R6BFPP-5N	CCW
42R6BFPP-5H	CCW
48R5BFYP	CCW

Step 6 – Connect AC Line Cord

A cord should be used for the AC power connection in order to properly seal against water through the liquid tight fitting. Connect the hot side of the line to “L1” and the neutral side to “L2.” Connect earth ground to the terminal labeled “CHASSIS GROUND.” Tighten the barrier terminal block screws to 6 lb-in.

Step 7 – Close and Seal the Enclosure

Close the hinged cover and tighten the four screws, one at each corner.

Step 8 - Connect to AC Power

After all other connections are made and the control is closed, connect the AC line cord to the AC power supply.

11