9.Disconnect the microphone cable (5) from the system board.
CAUTION: The display assembly will be unsupported when the following screws are removed. To prevent damage to the display assembly, support it before removing the screws.
10.Remove the T8M2.5×6.0 screw (1) that secures the display assembly to the computer.
11.Lift the display assembly (2) straight up and remove it.
NOTE: The display bezel is secured to the display assembly by and by the screws identified in step 12. After the bezel is removed, any residue of the adhesive should be cleaned from the inside edge of the bezel and the display panel metal frame. Then the new adhesive strip material should be put in place.
New adhesive strip material is included in all display bezel, display hinge, display panel cable, and display enclosure spare part kits, and is also available using spare part number
Component replacement procedures 49