3.Lift the front edge of the Bluetooth module compartment cover (2), swing it up and forward, and remove the cover.
4.Remove the following screw covers and screws:
(1)Four rubber screw covers. The rubber screw covers are included in the Rubber Kit, spare part number
(2)Six Torx T8M2.5×6.0 screws.
(3)One Phillips PM2.0×6.0 screw.
(4)One Torx T8M2.0×5.0 screw.
5.Turn the computer
6.Release the ZIF connector to which the TouchPad cable is attached and disconnect the TouchPad cable (1) from the system board.
Component replacement procedures 53