HP C5180, C5140, C5150 manual Remove all tape and lift display, Locate components

Start Here

1	USB cable users: Do not connect the USB cable
	until step A2.

Use this guide to set up the hardware and connect the HP All-in-One to either your computer or a working network. If you have problems during setup, see Troubleshooting later in the guide.

2

a

Remove all tape and lift display

b	a Remove all tape and protective film from
	the lid and from the front and back of the
	device.

b Lift the color graphics display and remove the protective film. You can adjust the height of the display to a position suitable for viewing.

3 Locate components

Windows CD

Mac CD

Documentation CD

This CD may be included for some languages where help is not available through the software.

HP Photosmart C5100 All-in-One series

Basics Guide

	4 x 6 in	USB cable*
	(10 x 15 cm) photo paper	*Purchased separately
Basics Guide

adapter	control panel faceplate	Ethernet cable*
	(may be pre-attached)
		*Purchased separately
		The contents of your box may differ
		Additional network equipment
power cord		specified later in the guide.
	ink cartridges

HP Photosmart C5100 All-in-One series Setup Guide