United States Stove B2045L, B2045N Cleaning / Servicing, Match Lighting Instructions, Pilot Flame

Page 14

OPERATING INSTRUCTIONS

WARNING

Wait 30 seconds before readjusting the heater when the control has been turned down to a lower setting.

MATCH LIGHTING INSTRUCTIONS

If the pilot will not light using the piezo ignitor, you can light the pilot with a match. First, locate the pilot. The pilot is located between the burner tube on the right end (facing the unit), inside the firebox. To light pilot with a match, move the gas control (knob B, pg. 13) to the pilot position and hold down. Light match and place near pilot. Once pilot is lit, continue to hold the knob for about ten seconds. Then follow steps 9 thru 13 on page 13.

CHECKING FLAME APPEARANCE

Flames from the pilot and burner should be visually checked when the heater is installed. In addition, a periodic check of the flames should be made.

PILOT FLAME

The pilot flame should always be present when the heater is in operation and should just touch the top of the thermocouple tip (FIGURE 9).

If the pilot flame does not touch the thermocouple, then the main burner is unlikely to function reliably (FIG- URE 10).

FIGURE 9. Pilot Flame

FIGURE 10. Incorrect Shape of Pilot Flame

 

CLEANING / SERVICING

Annual inspection and cleaning by your dealer or qualified service technician is recommended to prevent malfunction and/or sooting.

WARNING Turn off heater and allow to cool before cleaning.

Remove front screen, (see page 11). Carefully lift screen from locating stubs and set aside during cleaning. Refer to instructions on page 11 for installation of screen. Do not operate the unit with the screen removed.

Remove logs, handling carefully by holding gently at each end. Gloves are recommended to prevent skin irritation from ceramic. If the skin becomes irritated, wash gently with soap and water. Refer to manual for correct log placement.

Periodic Cleaning

14

Image 14
Contents Fuego Table of Contents Important Safety Information Product Features FeaturesSpecifications ContentsCodes Items Required for InstallationItems Required for Installation Installation Mantel Clearances GAS Connection Gas ConnectionGAS Pressure Check Rear View of 2045 Vent-Free Gas HeaterRemoving Front Screen LOG AssemblyProper Installation Sequence LOG PositioningOperating Instructions For Your Safety Read Before LightingFor Your Safety What to do if YOU Smell GASLighting Instructions Turn OFF GAS to ApplianceChecking Flame Appearance Cleaning / ServicingMatch Lighting Instructions Pilot FlameFlame Appearance FlamesHeater Assembly Replacement Parts Parts List for Heater Assembly KEY Description QTYBurner & LOG Assembly Parts List for Generator and LOG Assembly Troubleshooting Observed Problem Possible Cause RemedyTroubleshooting Optional Kits for the B2045 Wiring Diagram for Generator Assembly Optional Kits for the B2045Standard Wiring from Factory Wiring with the WSK60 Wall Switch KIT Page Limited Warranty Policy HOW to Order Repair Parts or Options United States Stove Company