United States Stove B2045L, B2045N manual Product Features

Page 4

IMPORTANT SAFETY INFORMATION

12.Do not place clothing or other flammable material near the appliance.

13.Keep appliance area clear and free from combustible materials, gasoline and other flammable vapors and liquids.

14.Any safety screen or guard removed for servicing, must be replaced prior to operating the heater.

15.This vent-free gas heater is intended to be smokeless. If logs appear to smoke, turn off the heater and call a qualified service person. Initial burn off may cause slight smoke and odor during the first four hours of operation.

16.Input ratings are shown in BTU per hour and are for elevations up to 2,000 feet. For elevations above 2,000 feet, input ratings should be reduced 4 percent for each 1,000 feet above sea level. Refer to the National Fuel Gas Code.

17.The appliance and its appliance main gas valve must be disconnected from the gas supply piping system during any pressure testing of that system at test pressures in excess of 1/2 psig (3.5 kPa).

18.The appliance must be isolated from the gas supply piping system by closing its equipment shutoff valve during any pressure testing of the gas supply piping system at test pressures equal to or less than 1/2 psig (3.5 kPa).

Do not use this room heater if any part has been under water. Immediately call a qualified service technician

19.to inspect the room heater and to replace any part of the control system and any gas control which has been under water.

PRODUCT FEATURES

Features:

Heating Efficiency - 99.9%

Wide BTU Range: 27,000 - 39,900.

Safe Operation - Oxygen Depletion Sensor (ODS).

No Electricity Required.

Fibre Ceramic Logs.

Push-Button Piezo Ignitor.

Clean Operation.

Wide Bay Front.

Easy Operation.

Heats up to 1,200 square feet.

FIGURE 1. 2045 Vent-Free Pedestal

Gas Heater.

4

Image 4
Contents Fuego Table of Contents Important Safety Information Product Features FeaturesSpecifications ContentsItems Required for Installation Items Required for InstallationCodes Installation Mantel Clearances GAS Connection Gas ConnectionGAS Pressure Check Rear View of 2045 Vent-Free Gas HeaterLOG Assembly Proper Installation SequenceRemoving Front Screen LOG PositioningFor Your Safety Read Before Lighting For Your SafetyOperating Instructions What to do if YOU Smell GASLighting Instructions Turn OFF GAS to ApplianceCleaning / Servicing Match Lighting InstructionsChecking Flame Appearance Pilot FlameFlame Appearance FlamesHeater Assembly Replacement Parts Parts List for Heater Assembly KEY Description QTYBurner & LOG Assembly Parts List for Generator and LOG Assembly Troubleshooting Observed Problem Possible Cause RemedyTroubleshooting Optional Kits for the B2045 Wiring Diagram for Generator Assembly Optional Kits for the B2045Standard Wiring from Factory Wiring with the WSK60 Wall Switch KIT Page Limited Warranty Policy HOW to Order Repair Parts or Options United States Stove Company