United States Stove 2927 owner manual Trouble Shooting Tips for Model, Two 90 degree bends be used

SUGGESTIONS FOR BURNING ANTHRACITE COAL

RULES FOR CONNECTOR PIPE INSTALLATION

1.With coal it is important to maintain a clean chimney. The chimney connector and chimney should be inspected at least twice monthly during heating season.

2.Keep the grate clear of ash and cinders. Use the shaker grate to keep the ashes from building up in the firebox.

3.Do not operate the unit with the ash door, feed door, or cabinet door open.

4.Anthracite coal burns with a short, blue flame with the coals having a glowing, red color. Before adding coal, when starting the fire, have a good hot log fire burning.

5.After having a log fire burning, add small amounts of coal until a bed of coal is built up.

6.A draft reading of -.05 to -.06 in w.c. is required for anthracite to burn.

			O
		D	P
			E
		E	N
		S
L	O
C

Fig. 10

1.The crimped end of the stovepipe fits inside the heater flue collar. Install addi- tional pipe and elbow with the CRIMPED END TOWARD THE HEATER. This will allow any condensation in the flue to run back into the heater.

2.Slope any horizontal pipe upward toward the chimney at least 1/4 inch for each foot of horizontal run.

3.You must have at least 18 inches of clearance between any horizontal pip- ing and the ceiling.

4.The pipe cannot extend into the chimney flue. (Fig. 8)

5.	Seal each connector pipe joint with
furnace cement. Also seal the pipe at
the chimney.
6.	Use 3 Sheet Metal screws at each
joint to make the piping rigid.
7.	It is recommended that no more than
two 90 degree bends be used in the
stovepipe installation as more than two
may decrease the amount of draw and
possible, use only corrugated (nonad-
justable) elbows. They are much more
airtight.
8.	The chimney connector must not
pass through an attic or roof space,
closet, or any concealed space, or floor,
ceiling, wall or combustive construc-

The draft wheel located on the feed door should be opened when burning coal. The draft wheel provides a source of secondary air that is needed when burning coal. Secondary air is needed because when coal burns, it gives off large quantities of volatile gases that need additional air before complete combustion can occur. This draft wheel may be adjusted to give the best performance depending on the particular needs of the user.

TROUBLE SHOOTING TIPS FOR MODEL 2927

tion.

LIST OF PROBLEMS	POSSIBLE CAUSE	SOLUTION
1. Smoking when feed	A) Insufficient Draft.	A) Set Thermostat high
door is open.	B) Clogged chimney or	B) Clean Chimney
	chimney connector.	C) Add raincap to chimney
2. Flame spillage when	A) Insufficient Draft.	A) Set Thermostat high
feed door is open.	B) Smothering fire when	B) Add fuel so as not to
	adding fresh fuel.	smother fire.
3. Creosote build-up	A) Burning green wood	A) Burn only seasoned
		wood.
	B) Thermostat setting too	B) Set thermostat higher to
	low type fuel.	attain higher fuel temp-
		eratures. This will aid in
		preventing build-up of
		creosote.
4. Heater does not heat.	A) Wood not seasoned	A) Allow wood to season
in		a dry, well ventilated
		area for 6 months.
	B) Blower control set too	B) Set blower control to a
	low.	higher temperature.
	C) Insufficient flue draft.	C) Set flue draft
		(See Page 9)

RIGHT

WRONG

Fig. 8

WRONG

12 9