Step 3 - Connect the Cables
Note: The cable that connects the printer to the computer is not supplied with the printer. You will need to purchase a parallel cable. HP recommends a
1 Turn the computer off.
2 Connect one end of the printer cable to the parallel port on the back of the printer and snap both clips onto the notches of the connector.
3 Connect the other end of the printer cable to the parallel port on the back of the computer and tighten the screws on the connector.
Note: | Do not share the parallel port with a Zip drive or scanner. |
4 Plug the power cord into the printer and then into a grounded outlet.
Step 4 - Install the Print Cartridges
1 Press the Power button to turn on the printer.
2 Open the printer cover.
The print cartridge cradles will move to the center of the printer.
3 Lift up the print cartridge latches.
4 Remove the color print cartridge from its package. | C1823A |
5 Gently remove the tape covering the ink nozzles. Be careful not to touch the ink nozzles or the
6 | Insert and push the print cartridge firmly down into the left cradle | 51645A | |
| and snap the cartridge latch onto the print cartridge. | ||
|
| ||
7 | Repeat steps 4 to 6 to install the black cartridge |
| |
| into the right cradle. |
| |
| Note: | Both print cartridges must be correctly |
|
|
| installed for the printer to work. |
|
8 | Close the printer cover. |
| |
|
|
| 5 |
Section 1 - Getting Started