HP LE1852ms 18.5-inch manual Setting Up the Monitor, Attaching the Monitor Base

Page 8

2 Setting Up the Monitor

To set up the monitor, ensure that the power is turned off to the monitor, computer system, and other attached devices, then follow the instructions below.

Attaching the Monitor Base

1.Lift the base from the monitor box and set it on a flat surface such as a table top.

2.Using both hands, lift the monitor from its box, position the pedestal over the base, and press down firmly to lock it in place. Be sure the base is securely locked in place and adjust the tilt angle to the desired position.

CAUTION: Do not touch the surface of the LCD panel. Pressure on the panel may cause non- uniformity of color or disorientation of the liquid crystals. If this occurs the screen will not recover to its normal condition.

Figure 2-1Attaching the Monitor Base

NOTE: To remove the base, press inward on the tab in the center of the underside of the base and pull the base from the pedestal.

2 Chapter 2 Setting Up the Monitor

Image 8
Contents HP Compaq LE1852ms LED Backlit LCD Monitor First Edition September Document Part Number About This Guide Iv About This Guide Table of contents Page Product Features HP LCD MonitorSetting Up the Monitor Attaching the Monitor BaseRear Components Component FunctionFront Panel Controls 1Monitor Front Panel ControlsAdjusting the Monitor Removing the Monitor Pedestal BaseMounting the Monitor Mounting the MultiSeat Solution to the Monitor 9Connecting the VGA Signal Cable Setting Up the Monitor Page Page Page 14Securing the Thin Client Power Adapter Turning on the MonitorInstalling a Cable Lock 15Installing a Cable LockProduct Support Finding More InformationReference Guide Recognizing Preset Display Resolutions Technical SpecificationsSpecifications Energy Saver Feature Entering User Modes