ASRock 970 Extreme4 manual Jumpers Setup, Jumper Setting, Clear Cmos Jumper

2.9 Jumpers Setup

The illustration shows how jumpers are setup. When the jumper cap is placed on pins, the jumper is “Short”. If no jumper cap is placed on pins, the jumper is “Open”. The illustration shows a 3-pin jumper whose pin1 and pin2 are “Short” when jumper cap is placed on these 2 pins.

Jumper		Setting
Clear CMOS Jumper
(CLRCMOS1)
(see p.12, No. 19)	Default	Clear CMOS

Note: CLRCMOS1 allows you to clear the data in CMOS. The data in CMOS in- cludes system setup information such as system password, date, time, and system setup parameters. To clear and reset the system parameters to de- fault setup, please turn of f the computer and unplug the power cord from the power supply. After waiting for 15 seconds, use a jumper cap to short pin2 and pin3 on CLRCMOS1 for 5 seconds. However, please do not clear the CMOS right after you update the BIOS. If you need to clear the CMOS when you just f nish updating the BIOS, you must boot up the system f rst, and then shut it down before you do the clear-CMOS action.

The Clear CMOS Switch has the same function as the Clear CMOS jumper.

30