Onkyo PR-SC886 Using the 12V Triggers, Zone 2 and Zone 3—Continued, Hookup, Main, Zone2, Zone3

Zone 2 and Zone 3—Continued

Using the 12V Triggers 3

The 12V triggers A, B, and C can be used to turn on 12V trigger-capable components automatically when they are selected as the input source. The triggers can be set so that they activate when a connected component is selected as the input source for the main room, Zone 2, Zone 3, or any combination of rooms.

When triggered, the output from a 12V TRIGGER OUT goes high (+12 volts, 100 milliamperes max).

4

Hookup
• Use a miniplug cable to connect the AV controller’s
12V TRIGGER OUT A, B, or C jack to the 12 V trig-
ger input on a connected component.
When several components are turned on simultaneously
by using triggers A, B, and C, depending on the type of
components, a large amount of current may be drawn		5
momentarily. To prevent this, you can delay trigger sig-
nals A, B, and C individually. Another application for
trigger delay is eliminating the “thump” noise that’s
sometimes heard when a source component is turned on.
Delaying the trigger signal for your power amplifier so
that it’s the last component to be turned on will accom-
plish this.
1	Press the [RECEIVER] REMOTE
	MODE button, followed by the
	[SETUP] button.
	The main menu appears onscreen.

2	Use the Up and Down [q]/[w] but-
	tons to select “6. Miscellaneous,”
	and then press [ENTER].
	The Miscellaneous menu appears.
		6.	Miscellaneous
	1.	Volume Setup
	2.	OSD Setup		6
	3.	Trigger A Setup
	4.	Trigger B Setup
	5.	Trigger C Setup
		MOVE	ENTER	ENTER RETURN RETURN SETUP EXIT

Use the Up and Down [q]/[w] but- tons to select “12V Trigger A, B, or C,” and then press [ENTER].

The 12V Trigger A/B/C Setup screen appears.

6-3.	12V Trigger A Setup
Delay			0sec
DVD			Main
VCR/DVR			Main
CBL/SAT			Main
GAME/TV			Main
AUX1			Main
AUX2			Main
TAPE			Main
TUNER			Main
CD			Main
MOVE	VALUE		RETURN		EXIT
		RETURN		SETUP

Use the Up and Down [q]/[w] but- tons to select “Delay,” and use the Left and Right [e]/[r] but- tons to select: 0 sec, 1 sec, 2 sec, or 3 sec.

When 0 sec is selected, the trigger sig- nal is output as soon as the input source is changed.

Use the Up and Down [q]/[w] but- tons to select an input source, and use the Left and Right [e]/[r] but- tons to select an option.

Off:

No trigger signal is output.

A 12-volt trigger signal is output when the connected component is selected as the source for:

Main:

Main room.

Zone2:

Zone 2.

Main/Zone2:

Main room or Zone 2.

Zone3:

Zone 3.

Main/Zone3:

Main room or Zone 3.

Zone2/Zone3:

Zone 2 or Zone 3.

Main/Zone2/Zone3:

Main room, Zone 2, or Zone 3.

When you’ve finished, press the [SETUP] button.

Setup closes.

120