Video Input Setup, HDMI Input Setup, Through, Auto, 480p

First Time Setup—Continued

Use the Up and Down [q]/[w] but- tons to select “Resolution”, and use the Left and Right [e]/[r] buttons to select:

Through:

Select this to pass video through the AV controller at the same resolution and with no conversion.

Auto:

Select this to have the AV controller automatically convert video at reso- lutions not supported by your TV.

(Not available when the “Monitor Out” setting is set to “Analog”.)

480p:

Select this for 480p output and video conversion as necessary.

720p:

Select this for 720p output and video conversion as necessary.

1080i:

Select this for 1080i output and video conversion as necessary.

1080p:

Select this for 1080p output and video conversion as necessary. (Not available when the “Monitor Out” setting is set to “Analog”.)

Source:

Output will be according to the res- olution level which was set with Resolution inside Source:

4-4. Picture Adjust. (Setting for each Source becomes possible.)

Use the Up and Down [q]/[w] but- tons to select “Component Out 2”, and use the Left and Right [e]/[r] buttons to select:

Monitor:

Select this if you’ve connected the

COMPONENT VIDEO MONI- TOR OUT 2/ZONE 2 OUT to a TV or other component in your main room.

Zone 2:

Select this if you’ve connected the

COMPONENT VIDEO MONI- TOR OUT 2/ZONE 2 OUT to a TV in Zone 2.

When Monitor is selected, the COM-

PONENT VIDEO MONITOR

OUT 2/ZONE 2 OUT outputs the same video as the COMPONENT VIDEO MONITOR OUT 1.

7	Press the [SETUP] button.
	Press the [SETUP] button.
	Setup closes.

Notes:

•If the video source contains information that restricts output at high-resolutions, 720p or 1080i content will not be converted.

•See page 30 for charts showing how the “Monitor Out” and “Resolution” settings affect the video signal flow through the AV controller.

•This procedure can also be performed on the AV con- troller by using its [SETUP] button, arrow buttons, and [ENTER] button.