Onkyo PR-SC886 5 6 7 8, Advanced Setup—Continued, Use the Up and Down q/w but, Notes

Advanced Setup—Continued

5

6

7

8

Use the Up and Down [q]/[w] but- 9

tons to select “Subwoofer”, and then use the Left and Right [e]/[r] buttons to select:

Yes: Select if a subwoofer is con- nected.

No: Select if no subwoofer is con- nected.

Use the Up and Down [q]/[w] but- tons to select “Front”, and then

use the Left and Right [e]/[r] 10 buttons to select a crossover fre- quency.

Note:

Fixed at “Full Band” if “Subwoofer” (step 5) is set to “No”.

Use the Up and Down [q]/[w] but- tons to select “Center”, and then use the Left and Right [e]/[r] buttons to select a crossover fre- quency.

If no center speaker is connected, select

None.

Note:

Cannot select “Full Band” if “Front” (step 6) is set to anything other than “Full Band”.

Use the Up and Down [q]/[w] but- tons to select “Surround”, and then use the Left and Right [e]/[r] buttons to select a cross- over frequency.

If no surround left and right speakers are connected, select “None”.

Note:

Cannot select “Full Band” if “Front” (step 6) is set to anything other than “Full Band”.

Use the Up and Down [q]/[w] but- tons to select “SurrBack”, and then use the Left and Right [e]/[r] buttons to select a cross- over frequency.

If no surround back speakers are con- nected, select “None”.

Notes:

•Cannot be set if “Speaker Type” is set to “Bi-Amp” (page 55), “Sur- round” is set to “None” (step 8).

•Cannot select “Full Band” if “Sur- round” (step 8) is set to anything other than “Full Band”.

Use the Up and Down [q]/[w] but- tons to select “SurrBack Ch”, and then use the Left and Right [e]/[r] buttons to select:

1ch: Select if one surround back

speaker is connected.

2ch: Select if two (left and right) surround back speakers are connected.

Note:

Cannot be set if “Speaker Type” is set to “Bi-Amp” (page 55), “SurrBack” is set to “None” (step 9).

Continue with step 11 on the next page.

90