Onkyo PR-SC886 instruction manual Making Hdmi Connections, Step, Video Signals, Audio Signals

Connecting the AV Controller—Continued

Making HDMI Connections

Step 1:

Use HDMI cables to connect the AV controller’s HDMI jacks to your HDMI-compatible Blu-ray player/DVD player, TV, projector, and so on.

Step 2:

Assign each HDMI IN to an input selector. See “Video Input Setup” on page 50.

■Video Signals

Digital video signals received by the HDMI IN jacks are normally output by the HDMI MAIN OUT and SUB OUT for display on your TV. Composite video, S-Video, and component video sources can be upconverted for the HDMI outputs. See “Video Connection Formats” on page 29 for more information.

■Audio Signals

Digital audio signals received by the HDMI IN jacks are output by the speakers and headphones connected to the AV controller. Normally, they are not output by the HDMI outputs, unless the “Audio TV Output” setting is set to “On” (see page 111).

Hint!

To listen to audio received by the HDMI IN jacks through your TV’s speakers, set the “Audio TV Output” setting to “On” (see page 111), and set your DVD player’s “Audio TV Output” setting to PCM.

HDMI	HDMI
OUT	IN

Blu-ray player/

DVD player

TV

HDMIHDMI

Notes:

•The HDMI video stream is compatible with DVI (Digital Visual Interface), so TVs and displays with a DVI input can be connected by using an HDMI-to-DVI adapter cable. (Note that DVI connections only carry video, so you’ll need to make a separate connection for audio.) However, reliable operation with such an adapter is not guaranteed. In addition, video signals from a PC are not supported.

•When listening to an HDMI component through the AV controller, set the HDMI component so that its video can be seen on the TV screen (on the TV, select the input of the HDMI component connected to the AV controller). If the TV power is off or the TV is set to another input source, this may result in no sound from the AV controller or the sound may be cut off.

•When the “Audio TV Output” setting is set to “On” (see page 111), or “TV Control” is set to “Enable” (see page 112) and you’re listening through your TV’s speakers, if you turn up the AV controller volume control, the sound will be output by the AV controller’s speakers. To stop the AV controller’s speakers producing sound, change the settings, change your TV’s settings, or turn down the AV controller’s volume.

•The HDMI audio signal (sampling rate, bit length, etc.) may be restricted by the connected source component. If the picture is poor or there’s no sound from a component connected via HDMI, check its setup. Refer to the connected component’s instruction manual for details.

38