Onkyo PR-SC886 Speaker Level Calibration, Advanced Setup—Continued, Notes, Press the SETUP button

Advanced Setup—Continued

7 Use the Up and Down [q]/[w] but- tons to select a speaker, and use the Left and Right [e]/[r] but- tons to specify the distance. Specify the distance from the speaker to your listening position.

Notes:

• The “Center” distance cannot be set if the “Center” is set to “None” (page 89).

• The “SurrRight” and “SurrLeft” dis- tances cannot be set if the “Sur- round” is set to “None” (page 89).

• The “SurrBack R” and “SurrBack L” distances cannot be set if “Speaker Type” is set to “Bi-Amp” (page 55), “SurrBack” is set to “None” (page 89).

• The “Subwoofer” distance cannot be set if “Subwoofer” is set to “No” (page 90).

8	Repeat step 7 for each speaker.
9	Press the [SETUP] button.
	Setup closes.

Note:

This procedure can also be performed on the AV control- ler by using its [SETUP] button, arrow buttons, and [ENTER] button.

Speaker Level Calibration

These settings are set automatically by the Automatic Speaker Setup function (see page 58).

With the “Level Calibration” settings, you can adjust the level of each speaker while listening to the test tone so that the volume of each speaker is the same at the listen- ing position.

Notes:

•The speakers cannot be calibrated while the output of the AV controller is muted.

•The test tone is output at the standard level for THX, which is 0 dB (absolute volume setting 82). If you nor- mally listen at volume settings below this, be careful because the test tone will be much louder.

1

3-6

2, 7

1	Press the [RECEIVER] REMOTE
	MODE button.

2	Press the [SETUP] button.
	The main menu appears onscreen.

93