Advanced Setup—Continued

MultEQ XT

Audyssey MultEQ XT correction is active (see page 58).

Dynamic EQ

“Audyssey MultEQ XT” and “Dynamic EQ” becomes active (see page 58).

Dynamic Vol(Light)

“Audyssey MultEQ XT”, “Dynamic EQ”, and “Dynamic Volume (Light Compression Mode)” becomes active (see page 58).

This setting prevents loud and soft sounds from being much louder and softer respectively than average sounds.

Dynamic Vol(Heavy)

“Audyssey MultEQ XT”, “Dynamic EQ”, and “Dynamic Volume (Heavy Compression Mode)” becomes active.

This setting affects volume the most, causing all sounds to be of equal loudness.

5

Use the Down [w] button to select

 

“Channel”, and then use the Left

 

and Right [e]/[r] buttons to

 

select a speaker.

 

 

You can select: “Front”, “Center”, “Sur-

 

round”, “SurrBack”, or “Subwoofer”.

 

2–5.

Equalizer Settings

 

 

Equalizer

 

Manual

 

Channel

 

Front

 

25Hz

 

0dB

 

40Hz

 

0dB

 

63Hz

 

0dB

 

100Hz

 

0dB

 

160Hz

 

0dB

 

250Hz

 

0dB

 

400Hz

 

0dB

 

MOVE

VALUE

RETURN RETURN SETUP EXIT

6

Use the Up and Down [q]/[w] but-

 

tons to select a frequency, and

then use the Left and Right [e]/[r] buttons to adjust the level at that frequency.

You can select: “25Hz”, “40Hz”, “63Hz”, “100Hz”, “160Hz”, “250Hz”, “400Hz”, “630Hz”, “1000Hz”, “1600Hz”, “2500Hz”, “4000Hz”, “6300Hz”, “10000Hz”, or “16000Hz”. And for the subwoofer, “25Hz”, “40Hz”, “63Hz”, “100Hz”, or “160Hz”.

The volume at each frequency can be adjusted from –6 to +6 dB in 1 dB steps.

Tip:

Low frequencies (e.g., 160Hz) affect bass sounds; high frequencies (e.g., 6300Hz) affect treble sounds.

7

Use the Up and Down [q]/[w] but-

 

tons to select “Channel”, and

then use the Left and Right

[e]/[r] buttons to select another speaker.

Repeat steps 6 and 7 for each speaker.

8

Press the [SETUP] button.

 

 

The setup menu closes.

Notes:

When the listening mode is set to Direct or Pure Audio, no effect will be produced.

The Equalizer settings have no effect on 176.4/ 192 kHz input signals.

This procedure can also be performed on the AV con- troller by using its [SETUP] button, arrow buttons, and [ENTER] button.

96

Page 96
Image 96
Onkyo PR-SC886 MultEQ XT, Dynamic EQ, Dynamic VolLight, Dynamic VolHeavy, Channel, and then use the Left, Select a speaker