Zone 2 and Zone 3—Continued

Zone 2/Zone 3 Out Settings

If you’ve connected your Zone 2 or Zone 3 speakers to an amp with no volume control, set the “Zone2 Out” or “Zone3 Out” setting, respectively, to “Variable” so that you can set the zone’s volume, balance, and tone on the AV controller.

1

Press the [RECEIVER] REMOTE

 

 

MODE button, followed by the

 

[SETUP] button.

The main menu appears onscreen.

If the main menu doesn’t appear, make sure the appropriate external input is selected on your TV.

2 Use the Up and Down [q]/[w] but- tons to select “7. Hardware Setup”, and then press [ENTER]. The “Hardware Setup” menu appears.

3

Use the Up and Down [q]/[w] but-

 

tons to select “2. Zone2/Zone3”,

 

and then press [ENTER].

 

The “Zone2/Zone3” screen appears.

 

7-2. Zone2/Zone3

 

 

Zone2 Out

Fixed

 

Zone3 Out

Fixed

MOVE

VALUE

RETURN

RETURN

SETUP

EXIT

4 Use the Up and Down [q]/[w] but- tons to select “Zone2 Out” or “Zone3 Out”, and use the Left and Right [e]/[r] buttons to select:

Fixed:

The Zone 2 or Zone 3 volume must be set on the amp in that zone.

Variable:

The Zone 2 or Zone 3 volume can be set on the AV controller.

5

Press the [SETUP] button.

 

 

Setup closes.

 

 

Note:

This procedure can also be performed on the AV control- ler by using its [SETUP] button, arrow buttons, and [ENTER] button.

Using Zone 2 and Zone 3

This section explains how to use Zone 2 and Zone 3.

ZONE 3

ZONE 2

TONE

OFF

,

STANDBY

ON

INPUT

SELECTOR

ZONE3

ZONE2

MUTING

LEVEL–,

LEVEL+

117

Page 117
Image 117
Onkyo PR-SC886 instruction manual 117, Zone 2/Zone 3 Out Settings, Using Zone 2 and Zone