Onkyo PR-SC886 AM Frequency Step Setup on some models, Changing the Input Display

First Time Setup—Continued

AM Frequency Step Setup (on some models)

For AM tuning to work properly, you must specify the AM frequency step used in your area. Note that when this setting is changed, all radio presets are deleted.

1	Press the [RECEIVER] button,
	followed by the [SETUP] button.
	The main menu appears onscreen.

2 Use the Up and Down [q]/[w] but- tons to select “7. Hardware Setup”, and then press [ENTER]. The “Hardware Setup” menu appears.

7.Hardware Setup

1.Remote Control

2.Zone2/Zone3

3.Tuner

	4.	Analog Multich
	5.	HDMI
	6.	Network
		MOVE	ENTER ENTER RETURN RETURN SETUP EXIT
3	Use the Up and Down [q]/[w] but-
	tons to select “3. Tuner”, and
	then press [ENTER].
	The “Tuner” menu appears.
		7–3.	Tuner
	AM Freq Step		9kHz

5	Press the [SETUP] button.
	Setup closes.

Note:

This procedure can also be performed on the AV control- ler by using its [SETUP] button, arrow buttons, and [ENTER] button.

Changing the Input Display

If you connect an u-capable Onkyo MiniDisc recorder, CD recorder, or RI Dock to the TAPE IN/OUT jacks, or connect an RI Dock to the AUX 1 jacks, for u to work properly, you must change this setting.

This setting can only be changed on the AV controller.

1, 2 1, 2

1	Press the [TAPE] or [AUX 1] input
	selector button so that “TAPE” or
	“AUX1” appears on the display.
	or

VALUE RETURN RETURN SETUP EXIT

4 Use the Up and Down [q]/[w] but- tons to select “AM Freq Step”, and then use the Left and Right [e]/[r] buttons to select:

10kHz: Select if 10 kHz steps are used in your area.

9kHz: Select if 9 kHz steps are used in your area.

2

(3 seconds)

or

(3 seconds)

Press and hold down the [TAPE] or [AUX 1] input selector button (about 3 seconds) to change the setting.

Repeat this step to select MD, CDR, or DOCK.

For the TAPE input selector, the setting changes in this order:

TAPE → MD → CDR

→	DOCK
	→

For the AUX 1 input selector, the set- ting changes in this order: AUX1 ↔

DOCK

Note:

DOCK can be selected for the TAPE input selector or AUX 1 input selector, but not both at the same time.

57