Onkyo PR-SC886 Speaker Settings, Tons to select 1. Speaker Set, Tings, and then press Enter

First Time Setup—Continued

Speaker Settings

If you change these settings, you must run the auto- matic speaker setup again (see page 58).

1

2, 3 2–4

1, 5

To use bi-amping, you must change the “Speaker Type” setting. For hookup information, see page 25.

Notes:

•When bi-amping is used, the AV controller is able to drive up to 5.1 speakers in the main room.

•Before you change these settings, turn down the vol- ume.

The onscreen menus shown in this manual may be slightly different from what you see on your TV.

1	Press the [RECEIVER] button,
	followed by the [SETUP] button.
	The main menu appears onscreen.

If the main menu doesn’t appear, make sure the appropriate external input is selected on your TV.

2 Use the Up and Down [q]/[w] but- tons to select “2. Speaker Setup”, and then press [ENTER]. The “Speaker Setup” menu appears.

2.Speaker Setup

1.Speaker Settings

2.Speaker Config

3.Speaker Distance

4. Level Calibration

5. Equalizer Settings

6. THX Audio Setup

3	Use the Up and Down [q]/[w] but-
	tons to select “1. Speaker Set-
	tings”, and then press [ENTER].
	The “Speaker Settings” menu appears.
	2–1.	Speaker Settings
	Speaker Type	Normal

MOVE VALUE RETURN RETURN SETUP EXIT

4 Use the Up and Down [q]/[w] but- tons to select “Speaker Type”, and use the Left and Right [e]/[r] buttons to select:

Normal:

Select this if you’ve connected your front speakers normally.

Bi-Amp:

Select this if you’ve connected your front speakers for bi-amped opera- tion.

5	Press the [SETUP] button.
	Setup closes.

Note:

This procedure can also be performed on the AV control- ler by using its [SETUP] button, arrow buttons, and [ENTER] button.

55