Polycom 3725-77601-001H manual Security Settings

Dial Plan Setup Operations

Field	For the endpoint systems at the site being provisioned...
FECC Type of Service	Specify the IP Precedence or Diffserv value for Far End Camera Control packets.
Value
Type of Service Field	Specify the service type and the priority of IP packets sent to the system for video, audio,
	and far-end camera control:
	• IP Precedence — Represents the priority of IP packets sent to the system. The value
	can be between 0 and 5.
	• DiffServ — Represents a priority level between 0 and 63. If this setting is selected,
	enter the value in the Type of Service Value field.
Maximum	Specify the Maximum Transmission Unit (MTU) size used in IP calls. If the video
Transmission Unit Size	becomes blocky or network errors occur, packets may be too large; decrease the MTU. If
(bytes)	the network is burdened with unnecessary overhead, packets may be too small; increase
	the MTU.
Enable PVEC	Allows the endpoint system to use PVEC (Polycom Video Error Concealment) if packet
	loss occurs. PVEC delivers smooth, clear video over IP networks by concealing the
	deteriorating effects of packet loss
Enable RSVP	Allows the endpoint system to use Resource Reservation Setup Protocol (RSVP) to
	request that routers reserve bandwidth along an IP connection path. Both the near site
	and far site must support RSVP in order for reservation requests to be made to routers
	on the connection path.
Enable Dynamic	Specify whether to let the endpoint system automatically find the optimum line speed for
Bandwidth	a call.
Maximum Transmit	Specify the maximum transmission line speed.
Bandwidth (Kbps)
Maximum Receive	Specify the maximum reception line speed.
Bandwidth (Kbps)
Security Settings
Security Profile	Read-only field. Displays the security level of the CMA system.
Use Room Password	Specify whether the local endpoint system password and remote access password are
for Remote Access	the same.
Room Password	Enter or change the local endpoint system password here.
	When the local password is set, you must enter it to configure the system Admin Settings
	using the remote control. The local password must not contain spaces.
Administrator ID	Enter the administrative account that should be used to access the endpoint system
	remotely.
Remote Access	For endpoint systems, enter or change the remote access password here.
Password	When the remote access password is set, you must enter it to upgrade the software or
	manage the endpoint systems from a computer. The remote access password cannot
	include spaces.

Polycom, Inc. 469