Onkyo PR-SC886 instruction manual 112, Network Settings, What’s DHCP?

Advanced Setup—Continued

Power Control

To link the power functions of -compatible components connected via HDMI, select “Enable”.

Disable: Power Control disabled.

Enable: Power Control enabled.

Notes:

•The “Power Control” setting can be set only when the above “Control” setting is set to “Enable”.

•HDMI power control only works with -com- patible components that support it and may not work properly with some components due to their settings or compatibility.

•When set to “Enable”, power consumption will increase.

•Refer to the connected component’s instruction man- ual for details.

TV Control

Set to “Enable” when you want to control the AV con-

troller from an -compatible TV that is con- nected to HDMI.

Disable: TV Control disabled.

Enable: TV Control enabled.

Notes:

•Set to “Disable” when the TV is not compatible or when it is unclear whether the TV is compatible or not.

•The “TV Control” setting can be set only when the above “Control” and “Power Control” settings are both set to “Enable”.

•Refer to the connected component’s instruction man- ual for details.

Note:

After changing the settings of the “Control”, “Power Control”, or “TV Control”, turn off the power to all connected pieces of equipment and then turn on again. Refer to the User’s Manuals for all connected pieces of equipment.

When linking to a TV that conforms to the CEC standard, the “Monitor Out” setting must be set to “HDMI Main”.

Network Settings

This section explains how to configure the AV control- ler’s network settings manually.

If your router’s DHCP server is enabled, you don’t need to change any of these settings, as the AV controller is set use DHCP to configure itself automatically by default (i.e., DHCP is set to Enable). If, however, your router’s DHCP server is disabled, for example, you’re using static IP addresses, you’ll need to configure these set- tings yourself, in which case, a knowledge of Ethernet networking is essential.

What’s DHCP?

DHCP (Dynamic Host Configuration Protocol) is used by routers, computers, the AV controller, and other devices to automatically configure themselves on a net- work.

1	Press the [RECEIVER] REMOTE
	MODE button, followed by the
	[SETUP] button.
	The main menu appears onscreen.

2 Use the Up and Down [q]/[w] but- tons to select “7. Hardware Setup”, and then press [ENTER]. The “Hardware Setup” menu appears.

7.Hardware Setup

1.Remote Control

2.Zone2/Zone3

3.Tuner

4.Analog Multich

5.HDMI

6. Network

MOVE ENTER ENTER RETURN RETURN SETUP EXIT

112