3.4.4 Storage Configuration
| BIOS SETUP UTILITY |
| |
Advanced |
|
| |
| Configure onboard | ||
Storage Configuration | serial ATA | ||
| controller. | ||
Onboard SATA Controller | [Enabled] |
| |
SATA Operation Mode | [IDE] |
| |
IDE1 Master | [Hard Disk] |
| |
IDE1 Slave | [Not Detected] |
| |
SATAII_1 | [Not Detected] |
| |
SATAII_2 | [Not Detected] |
| |
SATAII_3 | [Not Detected] |
| |
SATAII_4 | [Not Detected] | Select Screen | |
SATAII_5 | [Not Detected] | ||
Select Item | |||
eSATA_1 | [Not Detected] | ||
| +- | Change Option | |
| F1 | General Help | |
| F9 | Load Defaults | |
| F10 | Save and Exit | |
| ESC | Exit | |
v02.54 (C) Copyright |
Onboard SATA Controller
Use this item to enable or disable the “Onboard SATA Controller” feature.
SATA Operation Mode
Use this item to adjust SATA Operation Mode. The default value of this option is [IDE]. If you want to operate RAID function on SATA / SATAII HDDs, please select [RAID]. Configuration options: [AHCI], [RAID] and [IDE].
IDE Device Configuration
You may set the IDE configuration for the device that you specify. We will use the “IDE1 Master” as the example in the following instruction, which can be applied to the configurations of “IDE1 Slave” as well.
BIOS SETUP UTILITY
Advanced
Primary IDE Master
Device | :Hard Disk |
Vendor | :MAXTOR 6L080J4 |
Size | :80.0 GB |
LBA Mode | :Supported |
Block Mode | :16Sectors |
PIO Mode | :4 |
Async DMA | :MultiWord |
Ultra DMA | :Ultra |
S.M.A.R.T. | :Supported |
|
|
Type | [Auto] |
LBA/Large Mode | [Auto] |
Block | [Auto] |
PIO Mode | [Auto] |
DMA Mode | [Auto] |
S . M . A . R . T . | [Disabled] |
32Bit Data Transfer | [Disabled] |
Select the type
of device connected to the system.
| Select Screen |
| Select Item |
+- | Change Option |
F1 | General Help |
F9 | Load Defaults |
F10 | Save and Exit |
ESC | Exit |
v02.54 (C) Copyright
5 3