ASRock A75 Pro4/MVP manual Chassis Speaker Header

RESET (Reset Switch):

Connect to the reset switch on the chassis front panel. Press the reset switch to restart the computer if the computer freezes and fails to per- form a normal restart.

PLED (System Power LED):

Connect to the power status indicator on the chassis front panel. The LED is on when the system is operating. The LED keeps blinking when the sys-tem is in S1 sleep state. The LED is off when the system is in S3/S4 sleep state or powered off (S5).

HDLED (Hard Drive Activity LED):

Connect to the hard drive activity LED on the chassis front panel. The LED is on when the hard drive is reading or writing data.

The front panel design may differ by chassis. A front panel module mainly consists of power switch, reset switch, power LED, hard drive activity LED, speaker and etc. When connecting your chassis front panel module to this header, make sure the wire assignments and the pin assign-ments are matched correctly.

Chassis Speaker Header	Please connect the chassis
(4-pin SPEAKER 1)	speaker to this header.
(see p.12 No. 21)

Power LED Header

(3-pin PLED1)	1
			PLED-
(see p.12 No. 24)		PLED+
	PLED+

Please connect the chassis power LED to this header to indicate system power status. The LED is on when the system is operating. The LED keeps blinking in S1 state. The LED is off in S3/S4 state or S5 state (power off).

Chassis and Power Fan Connectors		Please connect the fan cables
(4-pin CHA_FAN1)		to the fan connectors and
(see p.12	No. 22)	match the black wire to the
		ground pin. CHA_FAN1/2/3 fan
(3-pin CHA_FAN2)		speed can be controlled through
(see p.12	No. 41)	UEFI or AXTU.
(3-pin CHA_FAN3)
(see p.12	No. 42)

(3-pin PWR_FAN1)

(see p.12 No. 1)

33