Batteries and chargers
6.1 | Batteries |
Utilization precautions.
Take care not to short the battery contacts on the Battery Pack with metal objects such as coins, keys or paper clips. Shorting the contacts can cause permanent damage.
The MIPT will need to have its Battery Pack recharged periodically.
Autonomy.
The Nickel Metal Hydride (NiMH) rechargeable Wireless Telephone Battery Pack gives you four hours of talk time or 80 hours of
Battery charging level.
In communication : when the battery level is low, the MIPT informs you of this via the battery low icon. During a call you will hear a low beep in the earpiece every six seconds. You only have 15 to 30 minutes of battery left.
Not in call: The battery icon is displayed whenever the battery pack charge level is low. The Low Battery message and a loud beep indicate that the charge level is extremely low. This happens when the user is not in communication. To be able to use your wireless telephone again, you must recharge the battery pack.
Removing and replacing the battery in MIPT 300 models.
Press the battery latch on the rear of the wireless telephone set. The battery is disengaged from the telephone. To replace the battery, insert the battery catch into the bottom of the battery compartment. Press the top of the battery so that it clicks into position. You should not exert any undue pressure to assemble the battery and telephone.
Removing and replacing the battery in MIPT 600 models.
To remove the Battery Pack press both battery release buttons. The Battery Pack will release. To replace the Battery Pack, slide the Battery Pack straight into the cavity. You should not have to force it.
6.2 | Desktop Charger |
22 |
Utilization precautions.
The Desktop charger is designed to charge the Nickel Metal Hydride (NiMH) Battery Packs. Full charging is accomplished in approximately one and a half hours. Chargers operate in a 50° to 85° F (10° to 30° C) environment. Do not expose them to freezing temperatures or direct sunlight.
Do not place anything in the charger other than the MIPT. You might damage the contacts. Bent contacts may hinder correct MIPT charging.
Indicator light.
If the MIPT is placed correctly, the red indicator light will come on. The indicator light does not come on if the charger is empty, if the telephone is incorrectly inserted or if the charger is not connected to the mains.
Charging indicator.
If the MIPT is in standby mode, it will display its extension number and Charging... If the MIPT is turned off, only Charging... will be displayed. The dots will be racing during the charging cycle. It is normal for the Battery Pack to become warm when charging.
Charge Complete.
When the MIPT is fully charged, Charge Complete will display. The indicator light will remain on until the Wireless Telephone is removed.
6.3 | Dual Chargers |
The Dual Charger is a
Place the handset face forward into the Dual Charger front slot. Place a spare Battery Pack in the rear slot, charging contacts down. The front slot takes charging precedence. The Battery Pack in the rear slot will begin charging when the handset in the front slot is fully charged or when the front slot is empty.