ASRock IMB-110 Series manual Pre-installation Precautions, Screw Holes

Page 11

Chapter 2: Installation

This is a mini-ITX form factor (6.7" x 6.7", 17.0 x 17.0 cm) motherboard. Before you install the motherboard, study the configuration of your chassis to ensure that the motherboard fits into it.

2.1 Pre-installation Precautions

Take note of the following precautions before you install motherboard components or change any motherboard settings.

1.Make sure to unplug the power cord before installing or removing the motherboard. Failure to do so may cause physical injuries to you and damages to motherboard components.

2.In order to avoid damage from static electricity to the motherboard’s components, NEVER place your motherboard directly on a carpet. Also remember to use a grounded wrist strap or touch a safety grounded object before you handle the components.

3.Hold components by the edges and do not touch the ICs.

4.Whenever you uninstall any components, place them on a grounded anti-static pad or in the bag that comes with the components.

5.When placing screws to secure the motherboard to the chassis, please do not over-tighten the screws! Doing so may damage the motherboard.

2.2Screw Holes

Place screws into the holes indicated by circles to secure the motherboard to the chassis.

11

Image 11
Contents IMB-110 Disclaimer Copyright NoticeContents Uefi Setup Utility Introduction Package ContentsSpecifications Support CD ConnectorsBios Feature Unique FeaturePage IMB Motherboard LayoutLAN Port LED Indications I/O PanelScrew Holes Pre-installation PrecautionsInstalling a SO-DIMM Installation of Memory Modules SO-DIMMExpansion Slot PCI Slot Installing an expansion cardDual Monitor Feature RI# Jumpers SetupBacklight Power Jumper +5V Onboard Headers and Connectors Front Panel Audio Header This is an interface for front 3W Audio AMP Output Pin Power Connector Please connect a DC Sata Power Connectors +5V Serial ATA3 SATA3 Hard Disks Installation Serial ATA Sata / Serial ATA2 SATA2 Hard Disks InstallationHot Plug and Hot Swap for SATA3 HDDs What is Hot Plug?What is Hot Swap? Hot Plug for Sata / SATA2 HDDsPoints of attention, before you process Hot Plug Sata / SATA2 / SATA3 HDD Hot Plug Operation GuideHow to Hot Unplug a Sata / SATA2 / SATA3 HDD How to Hot Plug a Sata / SATA2 / SATA3 HDDSet up Uefi Driver Installation GuideInstall Windows XP / XP 64-bit OS on your system Installing Windows XP / XP 64-bit Without RAIDUsing Sata / SATA2 / SATA3 HDDs without NCQ Set Up Uefi Using Sata / SATA2 / SATA3 HDDs with NCQ Set Up Uefi Uefi Menu Bar IntroductionMain Screen Navigation KeysInstant Flash Advanced ScreenNo-Excute Memory Protection CPU ConfigurationIntel Hyper Threading Technology Chipset Configuration Onboard LAN2 Marvell SATA3 Bootable Storage ConfigurationOnboard Sataii Mode Marvell SATA3 Operation ModeSuper IO Configuration Acpi Configuration Legacy USB Support USB ConfigurationUSB 2.0 Controller Hardware Health Event Monitoring Screen CPUFAN1 SettingBoot From Onboard LAN Boot ScreenSetup Prompt Timeout Bootup Num-LockSecurity Screen Exit Screen Drivers Menu Install Operating SystemSupport CD Information Running The Support CD
Related manuals
Manual 2 pages 21.07 Kb