ASRock IMB-110 Series manual Exit Screen

Page 42

3.7 Exit Screen

Save Changes and Exit

When you select this option, it will pop-out the following message, “Save configuration changes and exit setup?” Select [OK] to save the changes and exit the UEFI SETUP UTILITY.

Discard Changes and Exit

When you select this option, it will pop-out the following message, “Discard changes and exit setup?” Select [OK] to exit the UEFI SETUP UTILITY without saving any changes.

Discard Changes

When you select this option, it will pop-out the following message, “Discard changes?” Select [OK] to discard all changes.

Load UEFI Defaults

Load UEFI default values for all the setup questions. F9 key can be used for this operation.

Launch EFI Shell from filesystem device

Attempts to Launch EFI Shell application (Shell64.efi) from one of the available filesystem devices.

42

Image 42
Contents IMB-110 Copyright Notice DisclaimerContents Uefi Setup Utility Package Contents IntroductionSpecifications Unique Feature ConnectorsBios Feature Support CDPage Motherboard Layout IMBI/O Panel LAN Port LED IndicationsPre-installation Precautions Screw HolesInstallation of Memory Modules SO-DIMM Installing a SO-DIMMInstalling an expansion card Expansion Slot PCI SlotDual Monitor Feature Jumpers Setup RI#Backlight Power Jumper +5V Onboard Headers and Connectors Front Panel Audio Header This is an interface for front 3W Audio AMP Output Pin Power Connector Please connect a DC Sata Power Connectors +5V Serial ATA Sata / Serial ATA2 SATA2 Hard Disks Installation Serial ATA3 SATA3 Hard Disks InstallationHot Plug for Sata / SATA2 HDDs What is Hot Plug?What is Hot Swap? Hot Plug and Hot Swap for SATA3 HDDsSata / SATA2 / SATA3 HDD Hot Plug Operation Guide Points of attention, before you process Hot PlugHow to Hot Plug a Sata / SATA2 / SATA3 HDD How to Hot Unplug a Sata / SATA2 / SATA3 HDDDriver Installation Guide Set up UefiInstalling Windows XP / XP 64-bit Without RAID Using Sata / SATA2 / SATA3 HDDs without NCQ Set Up UefiInstall Windows XP / XP 64-bit OS on your system Using Sata / SATA2 / SATA3 HDDs with NCQ Set Up Uefi Introduction Uefi Menu BarNavigation Keys Main ScreenAdvanced Screen Instant FlashCPU Configuration Intel Hyper Threading TechnologyNo-Excute Memory Protection Chipset Configuration Onboard LAN2 Marvell SATA3 Operation Mode Storage ConfigurationOnboard Sataii Mode Marvell SATA3 BootableSuper IO Configuration Acpi Configuration USB Configuration USB 2.0 ControllerLegacy USB Support CPUFAN1 Setting Hardware Health Event Monitoring ScreenBootup Num-Lock Boot ScreenSetup Prompt Timeout Boot From Onboard LANSecurity Screen Exit Screen Running The Support CD Install Operating SystemSupport CD Information Drivers Menu
Related manuals
Manual 2 pages 21.07 Kb