ASRock IMB-110 Series manual Hardware Health Event Monitoring Screen, CPUFAN1 Setting

Page 39

3.4 Hardware Health Event Monitoring Screen

In this section, it allows you to monitor the status of the hardware on your system, including the parameters of the CPU temperature, motherboard temperature, CPU fan speed, chassis fan speed, and the critical voltage.

CPU_FAN1 Setting

This allows you to set CPU_FAN1’s speed. Configuration options: [Full On] and [Automatic Mode]. The default value is [Full On].

39

Image 39
Contents IMB-110 Disclaimer Copyright NoticeContents Uefi Setup Utility Introduction Package ContentsSpecifications Support CD ConnectorsBios Feature Unique FeaturePage IMB Motherboard LayoutLAN Port LED Indications I/O PanelScrew Holes Pre-installation PrecautionsInstalling a SO-DIMM Installation of Memory Modules SO-DIMMExpansion Slot PCI Slot Installing an expansion cardDual Monitor Feature RI# Jumpers SetupBacklight Power Jumper +5V Onboard Headers and Connectors Front Panel Audio Header This is an interface for front 3W Audio AMP Output Pin Power Connector Please connect a DC Sata Power Connectors +5V Serial ATA3 SATA3 Hard Disks Installation Serial ATA Sata / Serial ATA2 SATA2 Hard Disks InstallationHot Plug and Hot Swap for SATA3 HDDs What is Hot Plug?What is Hot Swap? Hot Plug for Sata / SATA2 HDDsPoints of attention, before you process Hot Plug Sata / SATA2 / SATA3 HDD Hot Plug Operation GuideHow to Hot Unplug a Sata / SATA2 / SATA3 HDD How to Hot Plug a Sata / SATA2 / SATA3 HDDSet up Uefi Driver Installation GuideInstalling Windows XP / XP 64-bit Without RAID Using Sata / SATA2 / SATA3 HDDs without NCQ Set Up UefiInstall Windows XP / XP 64-bit OS on your system Using Sata / SATA2 / SATA3 HDDs with NCQ Set Up Uefi Uefi Menu Bar IntroductionMain Screen Navigation KeysInstant Flash Advanced ScreenCPU Configuration Intel Hyper Threading TechnologyNo-Excute Memory Protection Chipset Configuration Onboard LAN2 Marvell SATA3 Bootable Storage ConfigurationOnboard Sataii Mode Marvell SATA3 Operation ModeSuper IO Configuration Acpi Configuration USB Configuration USB 2.0 ControllerLegacy USB Support Hardware Health Event Monitoring Screen CPUFAN1 SettingBoot From Onboard LAN Boot ScreenSetup Prompt Timeout Bootup Num-LockSecurity Screen Exit Screen Drivers Menu Install Operating SystemSupport CD Information Running The Support CD
Related manuals
Manual 2 pages 21.07 Kb