ASRock CONROE945 manual Boot Settings Configuration, Security Screen, Boot From Network

Page 40

3.5.1 Boot Settings Configuration

BIOS SETUP UTILITY

Boot

Boot Settings Configuration

Boot From Network

[Disabled]

Bootup Num-Lock

[On]

To enable or disable the boot from network feature.

 

Select Screen

 

Select Item

+ -

Change Option

F1

General Help

F9

Load Defaults

F10

Save and Exit

ESC

Exit

v02.54 (C) Copyright 1985-2005, American Megatrends, Inc.

Boot From Network

Use this item to enable or disable the Boot From Network feature.

Boot Up Num-Lock

If this item is set to [On], it will automatically activate the Numeric Lock function after boot-up.

3.6 Security Screen

In this section, you may set or change the supervisor/user password for the system. For the user password, you may also clear it.

BIOS SETUP UTILITY

Main

Advanced

H/W Monitor

Boot

Security

Exit

Security Settings

Supervisor Password

: Not Installed

User Password

: Not Installed

Change Supervisor Password

Change User Password

Install or Change the password.

 

Select Screen

 

Select Item

Enter

Change

F1

General Help

F9

Load Defaults

F10

Save and Exit

ESC

Exit

v02.54 (C) Copyright 1985-2005, American Megatrends, Inc.

4 0

Image 40
Contents ConRoe945PL-GLAN Copyright Notice DisclaimerContents Software Support Package Contents IntroductionSpecifications Connector Bios FeatureSee Caution Support CDPage CPU Motherboard Layout 19.1cm 7.5HD 8CH I/O Panel Table for Audio Output ConnectionPre-installation Precautions Screw HolesCPU Installation Page Installation of CPU Fan and Heatsink Installation of Memory Modules Dimm Installing a DimmInstalling an expansion card Expansion Slots PCI and PCI Express SlotsJumpers Setup PS2USBPWR1Onboard Headers and Connectors USB 2.0 Headers Chassis Speaker Header Black end White end 2-pin Hdmispdif Header Connection Guide Sataii Hard Disk Setup Guide Western DigitalDriver Installation Guide Untied Overclocking TechnologyBios Menu Bar Main Screen Navigation KeysAdvanced Screen CPU Configuration Boot Failure GuardCPU Host Frequency Spread SpectrumRatio Cmos Setting Ratio Actual ValueEnhance Halt State Max Cpuid Value LimitChipset Configuration Boot Graphic Adapter Priority Dram RAS# Activate to PrechargeOnBoard HD Audio Front Panel ControlAcpi Configuration IDE Configuration ATA/IDE ConfigurationIDE Device Configuration Combined OptionLBA/Large Mode PIO ModeDMA Mode Block Multi-Sector TransferPCIPnP Configuration PCI Latency TimerA.R.T Bit Data TransferFloppy Configuration Super IO ConfigurationOnBoard Floppy Controller Serial Port AddressParallel Port Mode ECP Mode DMA ChannelParallel Port Address EPP VersionUSB Configuration Hardware Health Event Monitoring ScreenUSB Controller USB 2.0 SupportBoot Screen Target CPU Temperature CCPU Quiet Fan Tolerance CBoot Settings Configuration Boot From NetworkBoot Up Num-Lock Security ScreenLoad Optimal Defaults Exit ScreenSave Changes and Exit Discard Changes and ExitInstall Operating System LGA 775 CPU Installation Live Demo ProgramSupport CD Information Running The Support CD