MSI 760GM manual Atlvid

▍BIOS Setup

▶DRAM Timing Mode

This field has the capacity to automatically detect all of the DRAM timing.

▶DRAM Drive Strength

This item allows you to control the memory data bus’ signal strength. Increasing the drive strength of the memory bus can increase stability during overclocking.

▶DRAM Advance Control

This field has the capacity to automatically detect the advanced DRAM timing. If you set this field to [DCT 0], [DCT 1] or [Both], some fields will appear and selectable.

▶1T/2T Memory Timing

This item controls the SDRAM command rate. Select [1T] makes SDRAM signal controller to run at 1T (T=clock cycles) rate. Selecting [2T] makes SDRAM signal controller run at 2T rate.

▶DCT Unganged Mode

This feature is used to Integrate two 64-bit DCTs into a 128-bit interface.

▶Bank Interleaving

Bank Interleaving is an important parameter for improving overclocking capability of memory. It allows system to access multiple banks simultaneously.

▶Power Down Enable

This is a memory power-saving technology. When the system does not access mem- ory over a period of time, it will automatically reduce the memory power supply.

▶MemClk Tristate C3/ATLVID

This setting allows you to enable/disable the MemClk Tristating during C3 and

ATLVID.

▶FSB/DRAM Ratio

This item allows you to select the ratio of FSB/ DRAM.

▶Adjusted DRAM Frequency (MHz)

It shows the adjusted Memory frequency. Read-only.

▶Onboard VGA Core Overclock

This item allows you to overclock the onboard VGA.

▶Onboard VGA Clock

This item will appear when Onboard VGA Over Clock sets to [Enabled]. It allows you to adjust the onboard VGA clock.

3-22