▶External
SATA 6GB/s Controller Mode
This item is used to specify RAID/ IDE/ AHCI mode for external SATA 6GB/s ports. ▶HD Audio Controller
This item allows you to enable/ disable the HD audio controller.
▶HPET
The HPET (High Precision Event Timers) is a component that is part of the chipset. You can enable it, and will provide you with the means to get to it via the various ACPI methods.
▶USB Configuration
Press <Enter> to enter the
▶USB Controller
This item allows you to enable/ disable the integrated USB 2.0 controller.
▶Legacy USB Support
Enable or disable support for USB keyboards, mice and floppy drives. You will be able to use these devices with operating systems that do not support USB.
▶Onboard USB 3.0 Controller
This item allows you to enable/ disable the USB 3.0 controller.
▶Hardware Monitor
Press <Enter> to enter the
▶CPU Smart Fan
Target
Controls CPU fan speed automatically depending on the current temperature and to keep it with a specific range. If the current CPU temperature reaches the target value, the smart fan function will be activated.
▶SYS Fan1/ 2 Control
These items allow users to select how percentage of speed for the SYSFAN1/ 2.
▶Power Management Setup
Press <Enter> to enter the
▶EuP 2013
Energy Using Products Lot 6 2013 (EUP) reduces power consumption when system is off or in standby mode.
Note: When enabled, the system will not support RTC wake up event functions. ▶Restore after AC Power Loss
This item specifies whether your system will reboot after a power failure or interrupt occurs. Settings are:
[Power Off] | Always leaves the computer in the power off state. |
[Power On] | Always leaves the computer in the power on state. |
[Last State] | Restore the system to the status before power failure or interrupt |
| occurred. |
▶Wake Up Event Setup
Press <Enter> to enter the