Programming | |
|
|
EN 37
3.Enter [9 5 9 #].
Two beeps sound after a successful test of the programming key. A long beep indicates that the programming key data is corrupt and must be erased to clear the corrupt data. Refer to Section 7.4.6 on page 38 for more information.
4.Enter [9 6 0 #] to exit from Installer’s Programming Mode.
Two beeps sound. The STAY and AWAY indicators are extinguished on the remote codepad and the system returns to the disarmed state.
5.Remove the programming key from the control panel.
Failure to exit from Installer’s Programming Mode before removing the programming key can corrupt the data in the programming key.
7.4.2Command 960 – Exit from Installer's Programming Mode
This command exits from Installer’s Programming Mode. You can exit from Installer’s Programming Mode from any location.
To exit from Installer’s Programming Mode:
Enter [9 6 0 #].
Two beeps sound and the system returns to the disarmed state. When using the remote codepad, the STAY and AWAY indicators are extinguished.
7.4.3Command 961 – Reset the Control Panel to Factory Default Settings
This command resets the control panel to factory default values. Default values are listed throughout this guide and in the programming sheets in
Section 25.0 Programming Sheets on page 101. You can reset the control panel from any location.
To reset the control panel to factory defaults:
1.Enter the Installer Code (the default is 1234) and press [#] to enter Installer’s Programming Mode. Two beeps sound and the STAY and AWAY indicators flash on the remote codepad to indicate that you entered Installer’s Programming Mode. The remote codepad displays the data stored in Location 000.
2.Enter [9 6 1 #].
Two beeps sound and the system is reset to the factory default values.
7.4.4Command 962 – Copy the Control Panel Memory to the Programming Key
This command copies the control panel memory to the programming key. You can only use the CC891 Programming Key with the
To copy the control panel memory to the programming key:
1.Enter the Installer Code (the default is 1234) and press [#] to enter Installer’s Programming Mode. Two beeps sound and the STAY and AWAY indicators flash on the remote codepad to indicate you entered Installer’s Programming Mode. The remote codepad displays the data stored in Location 000.
2.Connect the programming key to the PROGRAMMING KEY pins (next to the Auxiliary Module socket) at the top of the control panel found printed circuit board.
3.Enter [9 6 2 #].
Two beeps sound after the control panel memory is successfully copied to the programming key. A long beep indicates that the programming key is corrupt and must be erased to clear the corrupt data. Refer to Section 7.4.6 Command 964 – Erase the Programming Key on page 38 for more information.
4.Enter command [9 6 0 #] to exit from Installer’s Programming Mode.
The STAY and AWAY indicators are extinguished on the remote codepad to indicate the system is disarmed.
5.Remove the programming key from the control panel.
Failure to exit from Installer’s Programming Mode before removing the programming key can corrupt the programming key.
7.4.5Command 963 – Copy the Programming Key to the Control Panel
This command copies data from the programming key to the control panel. You can use the CC891 Programming Key only with the
To copy the programming key memory to the control panel:
1.Enter the Installer Code (the default is 1234) and press [#] to enter Installer’s Programming Mode. Two beeps sound and the STAY and AWAY indicators flash on the remote codepad to indicate you entered Installer’s Programming Mode. The remote codepad displays the data stored in Location 000.
2.Connect the programming key to the PROGRAMMING KEY pins (next to the Auxiliary Module socket) at the top of the control panel printed circuit board.
Bosch Security Systems, Inc. 12/08
