Domestic Dialing | |
|
|
EN 42
2 – Enable Alarm Link Call Back
If this option is selected and a callback telephone number is programmed, the remote programming computer must be connected to the telephone line programmed in the callback telephone number in Locations 159 to 174 (refer to Section 11.9 on page 51).
If this option is not selected, the installer can connect to a customer’s control panel from any remote location for Upload/Download operations without the control panel calling back to the remote computer. The customer can initiate a modem call from the codepad by holding down [6]. Refer to Section 8.0 Alarm Link Software on page 40 for more information.
4 – Terminate Alarm Link Connection on Alarm
If an alarm occurs when the control panel is communicating with a remote computer using the CC816 Alarm Link Software, the Alarm Link session is terminated and the relevant alarm message is transmitted to the base station receiver.
If an alarm occurs that does not have to be reported to the base station receiver, the session is not terminated. If this option is not selected and an alarm occurs, the Alarm Link software prompts the operator with a Terminate or Continue message.
9.0 Domestic Dialing
The locations of the primary and secondary telephone numbers for Receiver 1 or Receiver 2 are used only for base station and pager reporting. When either Receiver 1 or Receiver 2 is set up for domestic reporting, both the primary and secondary telephone numbers are ignored.
The domestic dialing telephone numbers are stored separately in Locations 550 to 597, which can store up to 48 digits. These 48 locations can store one or more telephone numbers. Depending on the length of each telephone number, you can store four or more different telephone numbers for domestic dialing.
If both Receiver 1 and Receiver 2 are set up for domestic reporting format, you still have 48 data locations. Both Receiver 1 and Receiver 2 use the same domestic telephone numbers. Programming separate domestic telephone numbers for Receiver 1 and Receiver 2 is not available for domestic dialing format.
Refer to Section 9.2 Setting Up and Programming Domestic Reporting on page 43 for more information.
9.1Domestic Dialing Function
When the control panel is activated into alarm, it dials the first programmed telephone number. If a busy or engaged tone is detected, the control panel hangs up and dials the sec telephone number (if one is programmed). The first call is counted as one unsuccessful dialing attempt. If the sec telephone number is also busy or an engaged tone is detected, the control panel hangs up and dials the third telephone number (if one is programmed) or attempts the first telephone number again.
If a busy tone is not detected, the control panel assumes the telephone was answered and sends its transmission. The transmission sequence consists of an identification beep, followed by a siren tone and a long pause. The transmission sequence is repeated until the control panel receives an acknowledgment tone during the pause. The control panel automatically hangs up after 2 min. If more than one control panel reports to the same telephone number, the identification beep allows the customer to verify the control panel that called. The identification beep is programmed in Location 039 of the Subscriber ID Number for Receiver 1 or Location 079 of the Subscriber ID Number for Receiver 2.
When set up for Domestic Dialing Format, the control panel attempts a maximum of six calls for each alarm event. This count includes any unsuccessful calls. The counter is reset if the zone is reactivated and the control panel attempts an additional six calls. The control panel stops dialing after six attempts or three successful calls. The control panel also stops dialing if a valid User Code is entered at the remote codepad.
If both Receiver 1 and Receiver 2 are programmed for domestic dialing, the maximum number of calls for each alarm event is twelve.
To acknowledge domestic dialing:
If the received call is not acknowledged during any of the transmission pauses by pressing the [*] button on a
Bosch Security Systems, Inc. 12/08
