| Dialer Options |
|
|
EN 52
Program the Ring Count to 14 to enable Answering Machine Bypass in the secondary mode. In this case, call the control panel and allow the phone to ring no more than twice and hang up. Wait a minimum of 8 sec and call the control panel again. The control panel answers on the first ring. If you do not wait the 8 sec, the control panel does not answer the call. To enable Answering Machine Bypass only when the system is armed, select Option 2 in Location 177 (refer to Section 12.1 Dialer Options 1 on page 52).
Set the Ring Count for the answering machine or facsimile machine to a value greater than two rings. Four to six rings is preferred.
Program a 0 into this location to disable the control panel from answering an incoming call.
11.11 Telephone Line Fault Options
Location 176
Default 0
1Display FAULT indicator when telephone line fails
2 Sound alarm when system is armed
4 Sound alarm when system is disarmed
8 Reserved
This location has three options. You can select any combination of these options by programming a single value. Calculate this value by adding the option bit numbers together. Refer to Section 7.3 Programming Option Bits on page 36 for more information.
The control panel monitors the telephone line. If the telephone line is cut or disconnected for longer than 40 sec, the control panel lights the FAULT indicator on the codepad. The FAULT indicator is extinguished after the telephone line is restored for longer than 40 sec.
Options 2 and 4 do not operate unless you also enable Option 1.
1 – Display FAULT indicator When the Telephone Line Fails
When this options is selected, the FAULT indicator flashes and the codepad buzzer beeps once per min if the control panel detects that the telephone line is disconnected. Refer to Section 3.13 Fault Descriptions on page 18 for more information.
2 – Sound Alarm When System Is Armed
You must also select Option 1 to use this option. If the control panel detects that the telephone line is disconnected when the system is armed, the horn speaker, bell, and strobe outputs are activated. If only one audible alarm per arming cycle is required, select the Lockout Telephone Line Fail Alarm option (2) in Location 179 (refer to Section 12.3 Dialer Options 3 on page 53).
4 – Sound Alarm when System Is Disarmed
You must also select Option 1 to use this option. If the control panel detects that the telephone line is disconnected when the system is disarmed, the horn speaker, bell, and strobe outputs are activated. If only one audible alarm per arming cycle is required, select the Lockout Telephone Line Fail Alarm option (2) in Location 179 (refer to Section 12.3 Dialer Options 3 on page 53).
If you program 7 in this location, the horn speaker, bell, strobe, and EDMSAT outputs are all activated when the system is armed or disarmed.
12.0 Dialer Options
Locations 177, 178, 179, and 180 have up to four options per location available for programming. You can select any combination of the options by programming a single value. Calculate this value by adding the option bit numbers together. Refer to Section 7.3 Programming Option Bits on page 36 for more information.
12.1Dialer Options 1
Location 177
1Dialer reporting functions allowed
2Remote arming by telephone allowed
4Answering machine bypass only when armed
8Bell 103 used for FSK format (disabled = CCITT V21)
1 – Dialer Reporting Functions Allowed
If you select this option, the dialer operates for all functions.
If you do not select this option, the communication dialer does not operate.
Upload/Download using the CC816 Alarm Link Software and telephone remote arming remains operational regardless of this setting.
