Bosch Appliances ICP-CC488| Installation Guide, Terminals and Descriptions, En, Operation

ICP-CC488 Installation Guide 22.0 Terminals and Descriptions

EN 97

Figure 25: DSRF Radio Receiver Wiring Diagram

1 2

1 – ICP-CC488Control Panel			2 – DSRF Receiver
Wiring and Power Up			Operation
1.	Remove power from the control panel.		The LED shows the status of the DSRF RF
2.	Connect the RF Receiver to the control panel as		Receiver:
	shown in Figure 25 on page 97.		• LED On – the module is functioning normally.
	Use 0.8 mm (22 gauge) or larger wire. Wire
			• LED Off – a power failure occurred or the
	length must not exceed 300 m (1000 ft).
3.	Apply power to the control panel.		module is not wired correctly.
	The red LED in the centre of the module lights.		• LED turns off momentarily – the module
			acknowledged receiving an RF signal from a
			remote RF device.
Figure 26:		Telecom Connection Diagram for Australia

1

5

2 3 4

9 7

10

2 3

6

97

8

1 – Control panel

2 – Red wire

3 – Yellow wire

4 – 6P4C plug (top view)

5 – 605 plug

6 – Internal phones

7 – Green wire

8 –	Telecom line
9 –	Black wire
10 –	611 socket
	1	(green): internal phone line
	2	(black): telecom line (street)
	3 and 4: not connected
	5	(yellow): internal phone line
	6	(red): telecom line (street)

Bosch Security Systems, Inc. 12/08 F01U089457-02