System and Consumer Options | |
|
|
EN 82
2 – Ignore AC Fail
If this option is selected, the MAINS indicator does not flash and the codepad does not beep every minute when the AC MAINS is disconnected from the control panel. If you want a programmable output to operate when the AC MAINS fails, use Output Event Type 1,4 AC Fail (refer to page 72).
If this option is selected, an AC Loss report (Contact ID Event Code 301) still reports to the base station receiver unless Locations 416 and 417 are programmed as 0 (refer to Section 15.22 System Status
– AC Fail Report on page 68).
4 – Zone Pulse Count Handover
If this option is selected, any zone pulse count readings are handed over and accumulate to any zone that is activated during the same arming cycle. Zone pulse count handover only operates with zone pulse count options 8 to 15. Refer to Section 14.3.3 Zone Pulse Count on page 61 and Section 14.3.4 Zone Pulse Count Time on page 61 for more information.
8 – Handover Delay To Be Sequential
If this option is selected, handover delay is sequential (that is, in numerical order from lowest to highest). If the sequence is broken before the Entry Time expires, an alarm occurs. If this option is not selected, handover delay follows the entry path if a Delay Zone is activated first. Refer to Section 14.3.2 Zone Types on page 61 for more information about Handover Zones.
18.4System Options 4
Location 495
Default 0
1Panel to power up disarmed (if power reset)
2 Arm/disarm tracking on power up
4 Internal crystal to keep time
8 Night arm station or RE005 installed
1 – Panel To Power Up Disarmed
If this option is selected, the control panel powers up in the disarmed state when the battery and AC MAINS are reconnected after the system is powered down.
If this option is not selected, the system is always powered up armed in AWAY Mode.
2 – Arm/Disarm Tracking on Power Up
If selected, the control panel keeps its current armed status in
Example
If the system is disarmed when the system is powered down, the system returns to the disarmed state when the system is powered back up.
4 – Internal Crystal To Keep Time
If this option is selected, the control panel uses the internal crystal (XTAL) to keep track of time. This option is useful in countries that do not have a constant MAINS frequency. If this option is not selected, the control panel uses the MAINS frequency as a time base to keep time.
8 – Night Arm Station, or RE005 Installed
Select this option to use the RE005
The Night Arm Station cannot operate a partitioned
18.5Consumer Options 1
Location 496
Default 0
1Test reports only when armed
2 Test report after siren reset
4 Auto arm in STAY Mode 1
8 STAY indicator to display Day Alarm status
1 – Test Reports Only When Armed
If this option is selected, Test Reports (Contact ID Event Code 602) are only sent when the system is armed. It is no longer necessary to send a Test Report with an Opening and Closing Report every day.
Most commercial premises are open during the working week, so a Test Report is not necessary because Open and Close Reports are sent at the programmed time. If you want to manually send a Test Report, press and hold [9] button until two beeps sound.
Refer to Section 15.28 Test Reporting Time to set the desired Test Report time. To set the first Test Report, refer to Section 5.1.2 Set the Number of Days until the First Test Report.
2 – Test Report after Siren Reset
Select this option to force the control panel to send a Test Report after the siren is reset. This can be used to indicate to the monitoring station that the control panel itself was not tampered with during the alarm period.
4 – Auto Arm in STAY Mode 1
Select this option if automatic arming in STAY Mode 1 is preferred to automatic arming in AWAY Mode.
Bosch Security Systems, Inc. 12/08
