| System Functions |
|
|
EN 25
To program the telco disarm sequence:
1.Enter the Installer Code and press [3][AWAY]. Three beeps sound and the STAY and AWAY indicators flash.
2.Press [2][AWAY] to change the telco disarming sequence.
Three beeps sound.
If a telco disarming sequence is already programmed, the sequence is displayed one digit at a time using the remote codepad indicators. Refer to Table 21 on page 24 for the indicators and their meanings.
If no telco disarming sequence is programmed, an additional two beeps sound after entering this mode. These two beeps normally sound after the last digit of the sequence is displayed.
3.Enter the desired call forward disable sequence. For example, program [# 6 1 #] to disable the call forward – no answer sequence, or [# 2 1 #] to disable the call forward – immediate sequence.
Remember that when you program a # in the telco arm sequence, you enter [STAY][2].
4.Press [AWAY].
Two beeps sound and the system returns to the disarmed state.
You can suspend the telco disarming sequence at any time.
To disable the telco disarming sequence:
Enter the Installer Code and press [3][AWAY][2] [AWAY][STAY][4][AWAY].
5.1.5Setting STAY Mode 2 Zones
This function allows the installer to select the zones that are automatically isolated when the system is armed in STAY Mode 2.
To arm the system in STAY Mode 2, press and hold
[0]until two beeps sound. Refer to Section 5.4.3 or Section 3.5 Arming The System in STAY Mode 2 for more information.
To set STAY Mode 2 zones:
1.Enter the Installer Code and press [4][AWAY]. Three beeps sound and the STAY indicator flashes.
2.Enter the number of the zone you want to automatically isolate and press [STAY]. The corresponding zone indicator flashes.
3.Repeat Step 2 for each zone you want to select.
As each zone is selected to be isolated, the corresponding zone indicator flashes. If you make a mistake, enter the incorrect zone number and press [STAY]. This zone is no longer selected to be isolated and the zone indicator is extinguished.
This function does not work on a partitioned
4.Press [AWAY].
Two beeps sound and the system returns to the disarmed state.
The indicators for the zones you selected and the STAY indicator are extinguished.
Example
If you want to select zones 2, 5, and 6, enter:
[1 2 3 4 4][AWAY][2][STAY][5][STAY][6][STAY] [AWAY]
You can disable all zones selected to be automatically isolated for STAY Mode 2 at any time. To disable STAY Mode 2 zones:
Enter the Installer Code and press [4][AWAY] [AWAY].
5.1.6Satellite Siren Service Mode
If the SS914 Satellite Siren (EDMSAT) is connected to Output 1, this function allows you to perform service work on the system without activating the satellite siren. The satellite siren returns to its normal working state the next time the system is armed.
To enter Satellite Siren Service Mode:
Enter the Installer Code and press [5][AWAY]. Three beeps sound.
5.1.7Turning Telephone Monitor Mode On and Off
Telephone Monitor Mode allows you to use the remote codepad for visual representation of data transmissions between the control panel and the base station receiver. The dialing sequence is also shown in this mode.
The codepad beeps once every two sec when Telephone Monitor Mode is active, whether the system is in Installer’s Programming Mode or normal operating mode. The first five indicators show the progressive steps during a transmission to the base station receiver.
After you activate Telephone Monitor Mode, hold down [9] until two beeps sound to initiate a Test Report.
