| System Functions |
|
|
EN 26
Table 23: Telephone Monitor Mode Indications
Zone LED | Dialing Event |
1Telephone line seized
2Dialing phone number
3Handshake received
4Data is being transmitted
5
None | Telephone line released |
To turn Telephone Monitor Mode on:
1.Enter the Installer Code and press [6][AWAY]. Three beeps sound.
2.Press and hold [9] until two beeps sound. A Test Report is sent.
To turn Telephone Monitor Mode off:
Enter the Installer Code and press [6][AWAY]. Two beeps sound.
You must exit from Telephone Monitor
Mode to resume normal operations.
5.1.8Walk Test Mode
Walk Test Mode allows you to test detection devices to ensure they are functioning correctly. Before activating Walk Test Mode, isolate any zones that are not required for testing. Refer to Section 3.11 Isolating Zones for more information. Use Locations 383 and 384 to enable Walk Test Mode Reports (refer to Section 15.2).
To enter Walk Test Mode:
1.Enter the Installer Code and press [7][AWAY]. Three beeps sound and the STAY and AWAY indicators flash. The codepad beeps once per sec when Walk Test Mode is active.
2.Unseal and seal the zones to be tested.
The codepad sounds one long beep and the horn speaker sounds one short beep each time a zone is sealed or unsealed.
3.Press [AWAY] to exit from this function. Two beeps sound and the STAY and AWAY indicators are extinguished. The system returns to the disarmed state.
5.1.9Event Memory Recall Mode
This function allows you to play back the last 40 system events that occurred. Event Memory Recall Mode reports all alarms and each arming or disarming of the system and helps with troubleshooting system faults. The events are displayed using the codepad indicators.
To enter Event Memory Recall Mode:
Enter the Installer Code and press [8][AWAY]. Three beeps sound. The events are played back by the codepad indicators in reverse chronological order.
Example
If the events occurred in the following order:
Table 24: Event Sequence
Sequence Event
1System armed in AWAY Mode
2Alarm in Zone 3
3Alarm in Zone 4
4System disarmed
The alarm memory plays back in this order:
Table 25: Event Memory Playback
Sequence |
| Indication | Event |
1 |
| All indicators off | System disarmed |
|
| except MAINS |
|
2 |
| Zone 4 and AWAY | Alarm in Zone 4 |
|
| indicators light |
|
3 |
| Zone 3 and AWAY | Alarm in Zone 3 |
|
| indicators light |
|
4 |
| AWAY indicator | System armed in |
|
| lights | AWAY Mode |
Each event is indicated by a beep and a lit indicator. Resetting a disarmed
After the last event, three beeps sound to indicate the end of playback. You can stop the replay at any time by pressing [AWAY].
If the system is armed in STAY Mode 1 or STAY Mode 2, the STAY indicator shows the event memory playback. There is no differentiation between STAY Mode 1 and STAY Mode 2.
If the control panel is powered down, the memory of all events is saved.
If a
