Remote Arming by Telephone | |
|
|
EN 34
To determine the area to which the codepad belongs:
1.Press and hold [8] until two beeps sound.
A zone indicator lights to show the area to which the codepad belongs.
Zone 1 = Area 1 codepad Zone 2 = Area 2 codepad
Zone 7 = Master Partitioned Codepad
If no zone indicator lights, the codepad is set up incorrectly or an incorrect codepad is used.
2.Press [AWAY] to exit from this mode.
5.4.12Send Test Report
Holding down [9] until two beeps sound transmits a Test Report (Contact ID Event Code 602) to test the dialing and reporting capabilities of the system without activating the sirens.
6.0 Remote Arming by Telephone
This feature allows you to arm your system from any remote location by telephone. For obvious security reasons, you cannot disarm the system using this method. A
To remotely arm your system by telephone:
1.Call the telephone number to which your control panel is connected.
When the control panel answers the incoming call, a short jingle sounds.
If you hear several strange sounding tones when the control panel answers the incoming call, the system is programmed for remote programming functions. Wait for a pause in the tones and follow Step 2 to arm the system remotely.
2.Hold the phone controller to the telephone’s mouthpiece and press and hold the button on the side of the unit for 3 sec.
You can alternatively press and hold [*] on the
3.Hang up the telephone. The system remains armed.
If the control panel does not answer the call, the system might be armed already, remote functions are not enabled, or the ring count is set to 0. To enable remote arming by telephone, select Option 2 in Location 177 (refer to Section 12.1 Dialer Options 1 on page 52). To set the number of rings before the control panel answers, refer to Section 11.10 Ring Count on page 51.
When both Remote Arming and Upload/Download are selected, the control panel answers the call expecting the remote computer. When this occurs, modem negotiating tones sound rather than the remote arming jingle.
Using this method with a partitioned
7.0Programming
The control panel programming options are stored in
a
Because the data retention time is up to ten years without power, no reprogramming is required after powering down the control panel.
You can change data as many times as required without additional specialized equipment. The memory is organized in locations, each of which holds the data for a specific function.
The maximum value you can program into any location is 15.
In general, the entire programming sequence consists of selecting the required location, and then entering or changing the current data. Repeat this procedure until you program all required data. The factory default settings are selected for reporting to the monitoring station in Contact ID format.
The Installer Code provides access only to the Installer’s Programming Mode and does not allow you to arm and disarm the system. You cannot enter Installer’s Programming Mode when the system is armed, or at any time during siren run time.
You can program the
•Remote codepad
•CC816 Alarm Link Upload/Download Software
7.1Programming with the Remote Codepad
To program the control panel using the remote codepad, the system must be disarmed with no alarm memory present.
To access Installer’s Programming Mode:
Enter the
Two beeps sound and both the AWAY and the STAY indicators flash simultaneously to indicate that you entered Installer’s Programming Mode.
Bosch Security Systems, Inc. 12/08
